ASD 12 Pack LED Disk Lights 4 Inch, 10W 5CCT 2700K-5000K 685LM CRI90+, Dimmable Flush Mount Ceiling Light Fixture, Low Profile Surface Mount Disc, Junction Box or Recessed Can Install, UL Energy Star

Easy install, great look, super amount of light and dimmable.

Let there be light.... more light! Swapped out some older MaxLite 985 lumen units for these with 1245 lumens. It's > 25% increase in brightness. I feel like I'll have my summer tan completed in just a few days. Tried these at 4K and 5K - both were good. Stayed with 4K. Good units. Easy to install.

We bought these lights to replace old ones on the outside of our home after we had new siding and soffit put on. They look great and were easy to install. Fits flush to the ceiling but looks like recessed lighting. A lot brighter than I expected them to be. The house look nice when it’s lit up at dark. Definitely recommend!!

The LED light ceiling lamp is nice and bright. But for this application I used your LED ceiling lamp to replace a high-intensity bulb in a six-foot tall torch light. The LED lamp therefore shines UP to the ceiling, my using it to replace the torch light's high-intensity bulb. Those long thin bulbs gets very hot and can have a short life spans.I took the high-intensity bulb, the protective glass over it and the aluminum shell that held the light, removing all of them from the tall torch lamp bowl. I then cut the wires from the torch lamp and wrapped them with black electrical tape so they would not short out, since they would be drawn through two drilled holes at the bottom of the aluminum shell, with edges that can be sharp.I then sawed a thin paint wooden sturring stick to size and used it as a bridge across where the glass had been located over the high intensity lamp, using the same screws to hold itI then used small snap lever wire holders to hold the wires from the lamp and the LED light, no room for the old lock nut. I then used two screws to mount the LED light onto the thin wooded sturring stick and twisted the dome in place over the LED light.It actually look pretty good, the LED light working well with the torch light's two position switch located on the pole. I connected the hot side of the polarized torch lamp cord to the black LED's wire. I did not use the ground because the lamp plug is two wire, not three. The LED bulb sits a little above the lamp's reversed LED bulb, but it's not objectionable. Now the torch lamp should be good for the next ten years without a bulb replacement.

I bought these to replace six ugly 6" can lights in my small kitchen. I somehow missed the info that the adapter kit is a separate purchase. Odd that I could purchase a box of 6 lights but had to purchase 12 kits. Installation was pretty easy. First, in order to attach the springy wires that clip into the existing 6" can you will need to drill out the four holes on the back of the light - use 7/16" bit. Factory paint made holes too small for provided screws. These were beautiful replacements for my can lights but I replaced 2700K lights with these 4000K lights...I need sunglasses in my kitchen now! 😎 Next purchase is a dimmer switch!

Good product, clean design, light amount and color is what I wanted.

These Leds look great in our room. very easy to install. We are very happy with the product.

Great lights for outdoor kitchen.