YZONA for Jeep Wrangler JK Rear Cargo Basket on OE Tailgate Compatible with 2007-2018 Jeep Wrangler JK & JKU Unlimited 2/4 Door, Spare Tire Cargo Rack, Luggage Storage Carrier (Bolt-On)

I have a adaptor on my back door to offset the 35in Spare tire. So I had to mount the support bars to the out side and modify the mount for basket rack. Other then this it fit great and is very sturdy and looks good.

Install was easy and instructions were good I even got to fit with my cb antenna. Just need to see how long the coating will last

ممتاز

Very sturdy at a great price. Coating is similar to scratch resistant bedliner. Take about a 1/2" on either side of the measurement due to the diameter of the bar extending slightly into the cargo area. Kept everything in place while traveling some rocky trails, no rattle, no flexing.

The good: Great finished product, sturdy, well made. See the finished product photo. Cooler fits nice. The bad: 1) Instructions are seriously lacking. Did not include special considerations with my 2023 Jeep JL. 2) Rack would not fit between my rubber bumpers that supported the spare tire at the bottom. Good news is you can remove them and they are not needed to support the spare as the new carrier structure does that. The bad news is that if you don't block the holes left by taking the bumpers out you will end up with water in your storage compartment when you go to the car wash (ask me how I know). SO... I cut the bumpers down as shown in the pictures and installed back into the holes. Something should have been provided with the kit to waterproof the exposed hole after removing the bumpers. There was no mention of bumpers in the instructions or poor photos. 3) Nothing in the instructions on how to route the wire for the brake light and backup camera. You will have to have someone hold the original spare tire holder while you get the mounting plate ready. I used a small table to support mine. Quite the pain as there is not much slack in the wire. Again, wire is not even addressed in the instructions. Frustrating experience but I'm happy with the end result. OH, edit, no instructions on how to use the washers. Se the photo with the bolt/washer/nut. Be sure to place the heavy/thick washer on the inside against the square tube or if you tighten it too tight you will crush the tube (if using the smaller washer and lock washer). Put the smaller washer and lock washer on the outside against the heavy metal plate. Otherwise if you crank down too hard on the bolt it can and will crush through the multihole tube if using the smaller washer on that side.