40 Pin Extra Tall Header (Push Fit Version)

Even though this is advertised as a push header, it does require soldering for a proper gpio pinout connection.Otherwise works as intended, no problems once soldered.

You need this if you are using a PI2RGB or RGB-PI and have a case which doesn't expose the pins.Works a treat.

After spending an hour of my life trying to remove the 2 black spacers (as I needed the extra length on the pins to pass through the socket on my ModMyPi relay board) I've finally concluded they simply cannot be removed. Really disappointed as the product description does not mention this fact. Funnily enough, if you browse to the same product on the ModMyPi website, they state there the shrouds/spacers cannot be removed. A shame they didn't include that vital detail on the amazon product page! Now I have a destroyed header, sore fingers and some ££ down the toilet.

Does the job well

Used this to add some space between a HAT and the Raspberry Pi (adding extra plastic spacers to the HAT to support it).Pushed the Tall Header onto the Pi, then pushed the HAT down onto the Tall Header.

Used this to extend my pins on my pi so I could fit my dac over my heat sink and fans.Worked.

Arrived as advertised exalant

Useful for stacking Pi hats