Universal Stainless Steel Vertical Pole Mount Adapter Bracket for CCTV Security Camera PTZ Dome Vertical Pole Mounting Bracket with 2 Loops (Set 1)

These worked great for mounting an Amcrest dome camera vertically to a small diameter outside pole. Not as well with a Hanwha dome, since the pattern on those is considerably larger. They have held up OK for several months, although the included straps rusted quickly.

These made mounting my security cameras a lot easier. Mount the camera to the pad and strap the clamp around the pole, then tighten it up. A year later and no rust!!

Sturdy bracket.

The slots aren't wide enough to except 1/4" bolts (u bolt in my case). I had to use a Dremel to grind slots wider after the brackets were already mounted on pole! I had a 4" diameter pole so it took "forever" to screw in (tighten) clamps. Being forewarned with good instructions I would have been prepared to use a power wrench. Also, the units come with a protected skin that needs to be removal. The skin breaks up as you remove it which means you have to start over and over again. These three factors add up to a lot of time wasted.

I am on the board of an RV park and we provide hoses at each site for water for drinking and hoses used for holding tank water ash outs…we previously had the hoses laying on the ground but with these clamps and plates we are able to get the hoses off the ground and on to pipe bollards.

Worked great to mount my camera to a pole. No issues.

I bought this item to mount a Ring Spotlight Plus Battery camera on a gutter downspout. The item is made of a very sturdy metal and was easily able to hold the camera. The included worm drive clamps were definitely long enough to go around the downspout with several inches to spare. I highly recommend this mount and would buy again.

The media could not be loaded. When the 2 clamps are made of stainless steel, the brackets aren't. It's on the thinner side too, but will give them a try.