Hitec RCD 35495S HS-5495BH HV Digital Karbonite Gear Sport Servo

As described

Been using Hi tec servos for years

Must have been his radio, these servos work fine. Maybe try a higher voltage? I am using a hitec receiver, I've used 6 of these servos so far with no issues like the one described about directional movement. They are fast, smooth and accurate. Also, one I got seemed to be packaged the same as all the others. I assume they are new. If anyone knows differently let me know.

Replaced stock traxxas 2975, Much better. Eliminated the silly servo saver Traxxas uses and went with the short arm that came in the Hi Tec pkg. Still going strong ! Actually broke the Traxxas bellcrank setup and this servo and arm still going like a Trooper. I'm happy, and just ordered one for the 'Road box" as a spare. Don't think I'll need it though. Impressive ruggged-ness. Some say it is 'Slower ' in reaction time, but I'm a basher, trails/backyards/beach etc... and I cant complain. It has massive torque too, if your up against a wall/tree or anything, this servo will turn a 5" paddle tire without any strain or stress. My Slash has nice,even control at higher speeds also. I'm happy with my choice here !!!!!!

This looks to be the best water proof servo I've seen so far. Its only rated to 1 meter. I checked out the interior. Board and pot can be pulled out a bit for service and looks to be well coated, so if it does leak it can be cleaned and dried easily. I'm using this for Big Gun Warship combat and we sink ships to about 10 feet, so I take additional steps to keep regular servo running like packing them with water prof lithium grease.I'll be giving this a deep test next week. If they can make one go ten feet I'll be ever happier

Love the high torque and good quality of these servos!

Worked as designed. Fast and waterproof. The screws to replace the gear sets are of ok quality so be sure to be careful when unscrewing them. The top strips easy. The seal seams a little small so be gentle with it as not to damage it. If you're careful, you'll never need to open it up.

There servos provide good torque to my 100CC gas powered RC airplane.

Great servo. I use the 645 in higher torque applications and these where a good amount of torque is required but a faster speed is desired.

I used it in my yak 54 .90 seagull models. Very good toke with 6v battery

アナログサーボより少し強いものが欲しくて購入。 タミヤアダプタがついてるので、それを使えば簡単にタミヤ車に積めるのも良い。 ただ、ニュートラルの位置は少しずれるので、組み上げたあとトリミング必須。

I purchased this servo to use in a GMADE Sawback GS01 crawler. It works fine with the exception that the torque is not quite enough at times (@7.4V). Speed is adequate for the application.

値段の割に、素晴らしいスペックです。現在ボートのラダーに使用していますが、キレも良く思ったより、消費電力も少ないせいか、電池の減りも少なく 一日遊ぶには充分です。皆さんも如何でしょうか。