22mm PZ22 Carburetor Compatible with Honda Trail CT90 CT110 Carb 1980-1986

Cheap. Worked perfectly out of the box

Bought for a Lifan 125. Looked over the carb inside and out, and looked to be of pretty good quality. I have gone through a lot of new carbs on this engine. Tuned all of them and it never ran like it should. Installed this carb, made 1 adjustment and it runs perfect. Starts really easy now and has a lot more power. I installed it on a ct70 clone. I flipped the fuel shutoff around and it was plug and play. Ive ridden this bike in this configuration for the last 2 years. On my first test ride with this carb it made so much more power I lost control of it and put it in a Bush. It has great throttle response. I have to relearn how to ride the bike.

Got this for an ‘81 ct110 because it was cheaper than a rebuild kit is. Amazed…it fit right and bike runs great! Only neg is the way the mount is setup with captured nuts makes for the factory bolts being a tad to short. They will work but don’t come full through the nut.

One problem was the fuel valve and nipples were installed 180 degrees off. When I turned it around I found one of the screws had been overtightened and stripped so It wouldn't seal. Luckily the old carb had longer screws which worked only because they hit the casting and created enough tension to hold the valve assembly in place. The trade off on cheap parts is often the poor quality control.

Great carb for little money. Didn't come with the filter element. Swapped that from another carb but it's a decent carb. Started first kick. Power made was fine. Replaced with Australian carb with a jet kit and it was a big boost in power.

I saw another review exactly like this after I purchased. Carb fits like it should, idles like it should, and low end acceleration is good. As soon as you get to cruising speeds it jerks and bogs all over the place. Switch to the next gear, fine until you hit cruising RPMs. I think china needs to re-learn how to make carburetors.

Excellent carburetor, fully adjustable, main jet on the slide, everything. Upgraded a Honda 90. Runs fine, no issues. Very satisfied.

Carburetor worked perfectly. I did have to remove connector for the fuel lines (fuel on/off/res dial) and point them the other direction. They were pointing in the wrong direction. Otherwise no issues.