Kegco LHU5S-4 Elite series four Product secondary CO2 draft beer regulator has a bold design with elite functionality. Secondary regulators are used when you are attempting to dispense two or more kegs off of the same CO2 tank at different pressures. This secondary regulator has four manual pressure release valves that release pressure at 55-65 psi, four large pressure adjustment knobs, and four brackets that allow it to be mounted to a wall or the inside of the keg refrigerator. In order to use This secondary regulator, you will still need a primary regulator with one output that connects to the secondary using a piece of air line. The LHU5S-4 has four 5/16" Barbs and four gauges that indicate how much CO2 pressure is inside of each keg.
M**R
Super sensitive adjustments
Not sure why but the pressure gauges are super sensitive. Just barely turning them causes the pressure to jump several PSI.I solved my issue. I had my primary regulator way too high which caused the sensitivity. Last night I set my primary regulator to 20PSI and now the KegCo regulators work perfectly.
J**K
Leaking
I lost an entire bottle of Co2 overnight because the unit had 2 small leaks. Leaks were very hard to find but once I isolated the leaks to the regulator, by submersing the regulator in bucket of water and finding the bubbles, I tightened the connections and now the unit is no longer leaking. This type of quality check should be done when the units are put together at the factory. Kegco, if you read this... you owe me a bottle of CO2
J**N
No leaks good looks - big and heavy
Installed this secondary regulator outside my kegerator and leak tested this with star sans. No leaks and held pressure after closing the tank overnight. Looks like they used some pipe sealant instead of the standard teflon tape. Really happy with this and it also looks great. Downside is this thing is incredibly heavy and large so it was difficult to mount. I ended up discarding the mounts and running some 3/4 EMT pipes up the bottom of the outside valves and attaching them to the backside if the kegerator with a 2x4.
H**
So far, not so good
I just plugged this regulator in and cannot figure why all 3 gauges are all the same pressure no matter how hard I crank down or loosen each valve. So far, I’d is basically a very expensive splitter unless I can figure it out. Any suggestions are great fully appreciate it
F**.
Works great to provide individual regulation for 3 kegs
I am a home brewer and have a kegerator that holds 3 cornys. Nice secondary regulator set. A little pricey, but you get what you pay for. It is just what I needed.
M**.
Very difficult to get a 3 way that works properly
If it worked properly it would be good. The third regulator wouldn’t hold low pressure and went to 30psi regardlesss of what was asked for
S**O
Leaking
Came with a slow leak on one of the inline regulators. Would have thought the seller or manufacturer performed a leak test prior to sale.
L**Y
Great reg, but
Great control and recently accurate gauges. The stopper bolt broke trying to remove it. No support from email so had to work through the problem. Drill and re-tap
T**T
I can't recommend this product.
Pressure gauges work fine but when I tried to take the plug out of the end and put a barb in it, itsnapped off I had to drill and tap to put the barb in I didn't have time to send it back. Ok to use as an as is triple but not for tying to other regulators or for changing fitting sizes it felt like fittings were welded in.
Trustpilot
1 week ago
1 month ago
