DERNORD 240V 4500W Tri-clamp Ripple Heating Element Stainless Steel Immersion Water Heater with 3-Wire Electrical Locking Plug (1.5 Inch Tri clamp)

Perfect for the repair and significantly less expensive than other sites. Fast shipping and well packaged.

I changed from the wired elements as this is easier to disconnect just by unplugging and then removing and the cord doesn't have to be dragged with it to clean in the sink. I got the 2 inch version and it works great. For some reason I get less gunk on these elements and the stuff doesn't seem to stick to them as much as the other ones I replaced. I put a silicone O-ring over the prongs and when you plug in the cord the O-ring fills the small gap where the connection is made, so if water somehow gets near this it won't get into the connection. I really like mine and I would buy these again.

Have 4 in a 600 gallon tank, just now had one go out after 3 years and many brews. We see around 6-7 degree per hour rise per element w/ 300 gallons.

Works like it should

Works perfect for my 1.5in triclamp for my mash ton/kettle. This allows me to boil water much faster than my old 120v setup. Easy to clean with a little bit of steel wool, doesnt hurt the element at all. I'll buy again if I need another.

I have purchased many of these for my brewery. Initially I had several failures, including scorched wort and burnt elements. Eventually it led to fry the receptacle on my control panel and melt away two brand new cables. I wouldn't recommend using these for brewing beer.

Use this to brew beer with and works great. Love that it has the tri clover clamp built in. Heats up my water super fast.

I bought 4 of these for a commercial brew kettle (4 BBL) and so far they are working great. Easy to install!

I use these heating elements for brewing beer. In the past I purchased similar elements from Chinese suppliers that did not have the three prong plug. They work too but you have to make a unction box and seal them so that they don't short out. The Dernord three prong connects make it a lot simpler, albeit at a cost.

Worked good both times I used it maybe too good, was a bit much for my application.

Ordered this element to go electric from natural gas brewing. Punched a hole in my pot and bought a controller. Heated 6 gallons (24 ish litres) from 8C to 50C in 15 minutes. Delivery was fast. First electric brew day tomorrow.

Get my mash going real fast makes very good spirits fast really glad I got a 5500 thanks guys speedy delivery from Amazon thumbs up keep up the good work

Finally got the right one but no cover for wires nice safety features. Thanks