Water-Resistance IP65, 12V Waterproof Flexible LED Strip Light, 16.4ft/5m Cuttable LED Light Strips, 300 Units 3528 LEDs Lighting String, LED Tape(White) Power Adapter not Included

I purchased these to install under a homemade cabinet. These have only been used indoors so I cannot speak to their IP rating or their UV resistance as others have noted there may be concerns in those areas. For my application, they work perfectly. They were easy to install and soldering wire connections to a switch and 9V battery was simple. The adhesive was a bit lacking when applied to the pine cabinet surface, but I did not intend to use the adhesive alone and used mounting staples to keep them in place. If you are relying on the adhesive alone to hold these you may run into some frustration unless you have a smooth surface and install them on long straight runs. For my application this was not an issue, since I was using mechanical fasteners. Brightness running off a 9V battery was exactly what I was looking for - not bright enough to add accent in full sunlight or a brightly lit room, but for little to no ambient light (which is what my application is) they are perfect.

Easy, very easy to set up and definitely enhances the aesthetics of your home. I purchased the white set. It makes the home look bright, modern and classy.I highly recommend for sure....

So I recently purchased a roll of these LEDs, as well as the Cool White 12V version. My project was to wire my new Matco Service Cart with blue LEDs underneath and white LEDs under the lid, wired to a magnetic switch on the N/O circuit. You open the lid, the magnets come apart, circuit closes, and the lights turn on. Close the lid, bye bye lights. Got all the wiring cut and crimped and tucked away nice and neat, and then attached the LEDs to their positions after wiping the surfaces down with mild soap, then water, then dry wipe. Whites have been up inside the lid since I put them there, not a single issue, but the blue... Well, they were all over the floor the morning after first install. I ran over half the strip with my cart's wheel before I noticed, destroying a large portion of them. Cut a new line from the remainder of the roll, and encountered the same thing later in the day... blue LEDs drooping and coming off the cart. I'll probably order another roll and just see if I got some poor glue in a batch, or what the case may be. Aside from that issue, the lights seem real sturdy, plenty flexible, certainly bright enough and they throw a nice indirect glow. Wiring them into their little connectors is troublesome, so I ended up soldering leads together when I had to, simpler that way for me. All in all, I'd recommend 'em if you're looking for some kind of lighty project.

The factory adhesive was worthless for my application.. I just used some clear silicone caulk to "glue" the light strip to my camper (the tape in the pictures to hold in place until silicone cured". Note: you will likely need to hardwire to a 12v source or purchase an adapter separately. I purchased the warm white color. The lights are bright and perfect for what I wanted and the price was great.

This product is inexpensive but worth the cost. The adhesion tape is not the best however if mounting on the underside of a wood deck railing or stair nose a low powered mechanical staple gun using t-50 staples spans the lights perfectly. (5/16 staples every 12" finished with a small tack hammer) I installed these lights and hardwired directly into the 12volt landscape transformer so they come on with the other lighting. This was an experimental purchase that just worked out so I purchased more. They provide couplers for longer runs without noticeable spaces. It is best to clean the mounting area with rubbing alcohol, make sure surface is dry.

Made sure 12vdc is greater than 2A, removed remotes battery shipping plastic, directions say "long press 5 sec" button, over and over and over, no workie...PLUS, never says what you do with the TWO extra Red & White cut wires ? Maybe its DOA - I may need to order Hundreds of these POSs until i find a good one= its FREE RETURNS. Maybe after a few thousands wasted kits someone might notice & help.

These are a very good deal, and I was able to connect them to 12V 1-amp converter (for 120V) that I had around the house. Unfortunately they are not the warm white 2700K advertised, and I would guess they are somewhere in the mid-3500K (cool white) range. They are quite bright for LEDs which will be useful for some applications, but in my case - for hidden cabinet lighting - they are a bit too bright given that they are cool white and not warm white. They installed easily, and it was simple to cut them to length. The adhesive backing works reasonably well, although it actually was peeling away from the light strip in some places even as I applied it.UPDATED: I figured out a quick-fix for overly bright cool-white light strips like these. Get some yellow-ochre oil paint. It takes about 5 minutes to dap a bit on each LED for the entire strip, and for under cabinet lighting (hidden) it works very well. I am attaching a "before and after" for just one bay of a cabinet where we wanted warm-white lighting, and the light from these cool-white LED strips was too harsh. In some cases we decided we needed a second coat, so don't worry about blocking the light - the paint can be wiped off or added to get the right tone.

I bought this to light the inside of my 17 foot diameter tent. I wasn't sure if it would be bright enough based on just the description alone. I bought one strip and figured I'd get another one later, if needed. As it turned out, the second one wasn't necessary. One strip is plenty bright.I didn't need to use the adhesive backed tape, as the tent had some small strings running the circumference inside. I simply looped the light strip around these and it stayed perfectly.I am running it off of an RV/Marine deep cycle battery. So I ran a line from the battery into the tent and hooked it up to a switch. Then I ran a line from the switch to the lights and now I have real indoor lighting inside my tent. No flashlights or lanterns required.These worked out very well. I would buy again if I ever need more.