Nilight60010C-A 36 Inch 234W Led Light Bar Combo 24V 12V For Truck SUV Van Camper Wagon Car Pickup Off-road Driving Work Light,2 Years Warranty

Easy install

My forth Nilight LED Light Bar as used on tractors and off road vehicles. Seems to be one of the better quality brands from Amazon. The combo flood and spot light features give me good side coverage.

Funciona muy bien, es una lástima que el país la prohibieron, para una 4x4 para andar de noche en los montes y lugares muy oscuro es perfecta

The media could not be loaded. Super Bright. brackets made install a bit difficult I would rather have had it sitting lower than the rack but ok with how it is. Overall simple to install expect to spens the day getting them installed. Super happy with the result.

great price used on 2003 Yukon

I have had this light for about a year and have had no problems with it. It is very bright and I have had no leaks or condensation in the light. You can spend lots of money on LED lights, but I find this one a great value. Very good build quality in this light.

Used this for my custom roof rack and I'm very happy. I got to use it out in the woods twice and it lights it up like it's day time! Mine is also a few years old now and it's holding up just fine, no yellowness in the lens or water penetration and none of the parts are rusting either.

I've bought and used Nilight products in the past and I've been satisfied with the quality for the price of their lights.This time the light bar showed up missing some of the hardware, all the M6-1.0 x 10mm bolts were MIA. Fortunately, I was replacing a Nilight 20" light bar with this 36" one, so I was able to use the old screws.The mounting bracket is a stamping that is bent at 90 degrees on both sides to form a U. One at least one of the brackets their break lines were off which prevented the slots from lining up correctly. Had to swap out a bracket, luckily, I only need 2 brackets for this installation, leaving me 2 spares.The other issue with the mounting bracket is that the inside dimension is 1 7/16" (36.5mm)while the point you attach the bracket to is only 1 3/16" (30.2mm). Trying to close this gap only further exaggerates the bad bends described above.Use caution when tightening the M6 bolts, the aluminum block they thread into will strip easily, use a 1/4" drive at most to avoid excess leverage.You might also want to have some M6 flat washers on hand, the ones supplied with the lights are typically thin enough that when you tighten the bolt down the washer will bend and slip through the slots.