24V 3.8A DC Adapter Cable Compatible with Airsense 10 CPAP Machine, Can Be Used with Flashfish 300Wh Power StationOnly

Yes, the plug is slightly shorter than the OEM plug on the ResMed AC wall adapter. But, it powers the unit just fine when connected to the 24VDC output of the FlashFish Power Station with no issues of popping off or otherwise failing. A necessary accessory if you need to power your APAP/CPAP machine...

My use case for this was to attempt to create a cable for use on a Philips DreamStation CPAP vs a ResMed. I have both brands of machine, but my intention is to use the DreamStation while camping due to its smaller size.The Philips unit runs off 12V (vs 24V on the ResMed), and it uses the same DC barrel connector as well. Since most power stations have a 12V cigarette socket output, this makes using the DreamStation very simple.The only modification necessary is to carefully cut away the strain relief on the output end and remove one of the two resistors inside. This will allow the center pin to provide the correct input voltage to the Philips and remove the "Check Power" error message. After splitting the strain relief, you should be able to carefully put it back and glue/tape it back together again. It's not going to look like a factory cable once your done, but it will at least work.For the low price, it was worth the gamble for me to try and get it working. Fortunately, it did work and I was able to save 4-5x the cost on a dedicated adapter.

While this cable claims to do exactly what I wanted to do - it doesn't work.The Airsense 10 requires 24VDC - I understand that and the lighter plug is designed for 12V but I wan't even planning to use the lighter plug - I wanted to wire directly to a solid 24VDC source I already had -While the plug appears to fit the machine - it doesn't go in far enough to connect properlyPutting 24V at the end of the cable. it only measured 19V at the plug - so something isn't right.Increasing the supply voltage to 28V resulted in 24 volts at the plug but it still wouldn't run the AirSense 10The wire is very thin inside the cable on top of not connecting and having a huge voltage drop.It's possible that this could work with the power station they suggest (which has a 24V out) but its hard to imagine - as it doesn't connect into the CPAP correctly in addition to dropping the voltage.I might have a faulty cable but others are mentioning the same things.

Bought for my Resmed CPAP thinking I would purchase a 24V battery. Its nice construction, looks well built even has the little tiny center pin that the Resmed power plug has.I changed my mind and purchased a 12 V 100 AH lithium-ion type battery and a voltage doubler that gives me the 24V I needed. The voltage doubler's loose some efficiency in the conversion to 24V. The 12V battery is more useful for other functions too.

Did was it was supposed to do!

This fits my CPAP nice and snug. It does the job and seems to be a little more heavy duty that the original connector.

As so many others have reported, this connector is the wrong size, and my AirSense 10 gives a warning about the connector not being properly inserted. FlashFish support has not responded to me. I had a previous version of this cable that fits just fine - it seems they changed the design.

This cable connects a Flashfish 300 power unit to a Airsense 10 CPAP machine. This 24 volt cable will power your CPAP longer than plugging into the AC port on the Flashfish power unit. This $10 cable is definitely worth what is costs.