Cat6 RJ45 'Easy' Connectors (Pack of 10) - Two Piece - for Category 6 / cat5e network cable

If you struggle to the point of repeated failure with ethernet connector assembly then these are great at making it achievable. My tips on it are to know the order of the wires and have them arranged with no twists, trim them down stepped from one side to the other slightly so you can insert the highest and the next one easier as it is slightly shorter than the one you have just inserted and so on. Check, check and triple check before trimming (reasonable amount of excess length outer sheath stripped to start with) and insert into the outer part of the connector. For me I did the brown wire the longest on the left with the lip at the back (definitely understand which way round they go in before inserting the first wire).

The quality of the product appears good but it definitely does not work for 'all' Category 6 cable. I tried to use this product with Cat 6A (1.2mm OD strand) and the 'Easy' part of the connector does not allow the strand to pass through it.

So much easier to use than the single piece terminal. It still takes a little time to get the wires lined up but you can see when they are in the correct order

I had a single cat 5e cable to feed through a wall to allow better network connection to my office (wifi extenders wouldn't do the job). I bought a crimper and some standard cat 5 connectors and went to work attempting to order and feed the wires into the connector. In the end I ran out of connectors as I had to keep trying, failing to get any signal through and then snip it off to try again! So I bought these 2 piece 'Easy' connectors which worked perfectly first time! Ideal for any DIY networking without having to buy loads of kit.

Maybe it's me, but I found the push-through connectors much easier to use, these seemed a bit of a faff, and if you lose the little bar which holds the cable, it leaves it useless. Not recommended by me, but I stress it might be the way I was trying to do it

I encountered two issues with this product:1) The holes on the loading bar aren't machined very well. From the same network cable, one pair can slide right in, but another pair almost seems slightly too thick to get through the holes, so you really have to force it.2) Even once you've got your cables loaded into the bar, I cannot for the life of me make it fit in the RJ45 plug. It gets part way and just gets stuck. I, again, blame most likely poor manufacturing of the loading bars for this.

Life saver, I spent hours trying to connect the normal type, these still took time, I'm a DIYer.Make sure you write down the color order of the wires on piece of paper, make sure you find the slightly curved side of the internal piece, and then decide wife way round you will be looking at the wires in the connector.Is hard to explain, but you could end up with it wired back to front and have to start again.

Easy to get cable colour alignment arranged into load bar, but when crimping it will either move out of place or connectors won't line up meaning not all 8 cables test positive, meaning useless and have to cut off and try again. Thus time consuming and wasteful, especially if you only have a short cable to start with.Correction: seems to be a trick is that if you keep the load bar as close to cable outer covering as possible before cutting and inserting into the plug it moves slightly less when crimping. Still not perfect or fool proof, but eventually managed to crimp a few in a row correctly.