SMA Male to Female Coax Coaxial Cable Adapter, Low Loss for WiFi & FPV Antenna Extension Cable Pack of 2

Using these on my nano vna, reduces the strain on the original connectors and makes it easier to use. No noticeable losses or signal issues with them.

This is actually a great product, if you have something you have to connect and disconnect repeatedly, like a tiny essay analyzer or some other piece of equipment or test device. These are great, it will keep you from wearing out the connector that's built into your device. As SMA connectors are only designed to be connected and disconnected a total of 50 times. At least according to the manufacturer. By adding one of these and just since you get down a little bit, you can wear this connector out. And once it it does wear out eventually you could just change it for one more and you're good to go, without damaging the connector on your original equipment. I use it on an aai antenna impedance analyzer, and it works great because if I destroy the connector on the analyzer changing it internally it's a real pain. So this is definitely worth the money, so far I haven't noticed any problems with impedance shift reflected power frequency response or anything, it's only a fraction of an inch of wire added to the circuit. So it would have very low stray capacitance or inductance, at least it frequencies below 10 ghz.

Bought these to save the wear and tear on my NanoVNA's connectors.

Purchased to prevent wear on the threads of the RF connectors on my NanoVNA. The cables and calibration pieces are changed frequently so I purchased these at the recommendation of a YouTuber. The threads are well machined and the fit is excellent.

They do the job.

Works exactly as it should. Great !!!

Simple product that does exactly what it is supposed to. I used it as a short extension.

These adapters help save the connections on my tinySA's and NanoVNA's because the test loads don't spin as easy as these adapters, thus causing undue stress upon the connectors. I would rather replace an adapter than replace a connector internal to my device. Mush easier.

SMA Male to SMA Female ordered and delivered promptly in 10 days. Well packaged and a clean, concise invoice enclosed. Very professional all around. Part quality appears good and is being used on a NanoVNA to protect the connectors on the PCB.

J'ai 3 scanners a connecter sur une nouvelle antenne et chacun a son connecteur différent . Cet adapteur règle cas du deuxième appareil et un autre ensemble a été commandé pour le dernier maintenant que je sais que c'est solide et rapide a changer .

Those two adapters work perfectly to protect the SMA connectors on my NanoVNA and TinySA.

Becareful, I don't know which is wrong, the desciption or the image! But I did not get what I was looking for! I got a connector that has a pin where there should be a hole! The other end should of had a pin but it has a hole instead!

Do not buy no center pin not worth it’s weight