Broan-NuTone 413001 Non-Ducted Ductless Range Hood with Lights Exhaust Fan for Under Cabinet, 30-Inch, White | Under Cabinet Exhaust Fan for Kitchen Ventilation

We replaced the stove fan we had. It was old and I had recently ruined the filter with a pan fire. This fit perfectly, looks nice and clean. Light and fan work perfectly. I didn’t hear much cussing while my husband put it up so it must be easy to put up because he is not a handyman. I am very pleased. I thought it was priced fair. Arrived on time. I would recommend.

I replaced a 43 year old mobile-home range hood because I was never able to use it due to the exhaust fan vent closure flap never working and the hole faced north; the direction we get all of our extreme cold and winter wind from so I had sealed the fan opening off. In the winter time if I did not keep the cupboards above open my cooking oils would freeze. The grease continued to build up even with continual cleaning until I could not stand it any more. I did not know they made a non-outside-vented hood range until I went looking for a new vent hood. Because the lip of the cupboard is a bit lower than the actual base of the cupboard I had to use some 3/4" plywood (2 pieces of 2" x 11") as "spacers" on both ends to make the hood level. I attached them to the bottom of the cupboard and then used shorter screws to attach the hood to the plywood. I used styrofoam insulation and heating-duct tape to seal off the original vent opening. The fan is very quiet and i could feel the difference in the low and high speeds although neither of them were real powerful. I have yet to need to use the fan since with the hot weather we are still having I have not used the stove top to cook any fatty foods. I like the white verse the brushed aluminum of the original hood; it makes it look lighter and brighter and should be easier to wipe off each time I clean. I did install this by myself and the only time it would have been convenient to have help is when I went to lift it up and attach it to the cupboard - I am just over 5' and of retirement age, but I made a couple of props to hold up the back and other side while attaching the first side. There are only two colored wires (white and black) which you need only to attach to the original white and black wires, and then attach the ground wire to the green screw. There is a plate covering the wires held on by a small black screw. There are 4 short screws provided (but I used longer and wider threaded screws) for attaching the hood.

Good quality for the price. Easy to install.

First, this hood looks fantastic. I upgraded all the appliances in a rental apartment to stainless steel, and this fits right in. It works great, is quiet, and the price was incredibly reasonable. I took off one star because it is tricky to install. In theory, there are keyhole slots, so you should be able to put the mounting screws in pace in the cabinet, and then slide the hood on and tighten the screws down. In practice, my cabinets, like pretty much all cabinets I have ever seen, have a 1" deep lip around the edges on the underside. That means the provided screws are not long enough to reach the bottom of the cabinet itself, since the hood is pressed up against the lip. Also there is no template provided, so it would take some pretty exact measuring to preset the screws in all four corners. In the end, I just had someone hold the hood in place, and used some longer screws to just zip into the underside of the cabinet body. It's a little hard to reach up and over the stove to get the screw gun angled correctly, so it was a bit frustrating, but I was able to finish up in about 20 minutes. Highly recommended product, just know that the installation might take some finessing.

Very nicely made and easy to install

Awesome item. Easy to install. Uses a normal light bulb, so super easy to replace. Very clean looking. I edited this review after hearing back from customer service about the original issue (see below) their suggestions worked and removed the residue from the protective plastic sticker that was on the hood. This item arrived with a protective blue plastic peel off piece across the front of the hood. After installation, I removed this blue plastic to find that there are marks all over the front of the hood now from that blue plastic. I tried first cleaning them off with just a soft rag and water nothing. Then I tried Windex that didn’t work. So I tried a soft drag with some Dr. Bronner‘s soap and that had no effect either. Otherwise it is a lovely hood. Not sure how to get rid of these ugly marks. I took a photo, but it’s very hard to photograph.

Under-cabinet ductless range hood was perfect fit for my kitchen made the kitchen cabinets look nice.

Bought this for a cheap stainless steel hood. Old one finally died, and I didn't want anything expensive because we will be putting in an over the range microwave soon, but until then we needed an exhaust fan. Install was super easy. It took me less than 10 mins and probably 2 of those minutes were just me walking up and down stairs to turn off and on the power to the kitchen. The box came left at my door wide open!!! Never had this issue with amazon before. I was initially worried, but on close inspection all was good. Only thing in the box was the Hood, which even though box was opened and damaged, was in perfect condition, and an instruction book, which I never even opened. The mounting screws were in a plastic bag under the wiring cover that you have to remove during install. At first I thought the screws were gone, but that was not the case. They were there. Look under your cover ! My cabinets have a frame ledge that comes down 1/2" below the bottom of the cabinet on the front and back. So, I either had to use a 1/2" spacer board in-between the hood and the cabinet or drill some new holes in the hood right on the front and back edge so I could screw into the ledges to mount the hood. I choose to drill in the new hood. I used a 3/16 drill bit and it worked perfect for the included screws. Next, I just punched out the back wire tab on the hood with a flat head screw driver, turned off the power to the kitchen, then held the hood up to the wall and pushed the power wires from the wall through the tab hole. After that I had my wife hold the very light hood up to the cabinet, made sure that we liked the placement of the hood and I screwed in the 4 included screws through the hood and into the cabinet. This whole step took less than 2 minutes. Next, all you have to do is wire nut the white wires from the hood to the white wire from the wall, Blacks to the Black and then attach your ground wire from the wall to the greenish/blue looking screw on the hood. After that, flip your power back on and test it. In my case all was good. And Finally run to the store and buy an appliance bulb because one is not included with this order. Enjoy.

Easy to install

Great range hood that suits the requirements of our kitchen. Looks great and works great as we've already installed it. Light is a bit dim, but overall we're happy with this purchase. Shipping was a bit of a nightmare. This package kept being held by Putolator for reasons that were never explained, however, we kept receiving emails indicating that our action was required to get this package back on track!?!?!? ! It did arrive on the latest possible date specified by Purolator. Product itself, is a very nice upgrade for our kitchen and looks great with our flat black cabinet hardware and accents. Price is great!

Muy practica para cocinas pequeñas

Fit it the spot where we were putting it

Excelente producto muy buena calidad gracias