Holder for Dremel 4000, 4200 for Vise and Table mounting PN DH-4000VT Yellow

Very nice. Was slightly large for my dremel model 395, so I added some stick-on rubber feet to the inner barrel to reduce the diameter a tiny bit.

Clamp arrived lightning fast and fit my Dremel 4300 perfectly. I may have over clamped it a bit but the crack propagated along through the lettering on the side. See the picture in how it makes a right angle along the "4" and then down through the "U". I used it for about one hour and was going slow to test my new CNC setup. 0.5mm depth cut and 20mm/min feed is pretty slow and shallow so the only thing I can think of is that I over tightened it or it had a weak spot. Regardless, I'd recommend the maker to remove lettering from the side of the clamp. Use a sticker or place somewhere else.

Great tool holder that Dremel should have made and sold priced too high, but just a tip: don't clamp it too tightly lest you crack it.

Advertised as fitting the 4200 Dremel but it’s very difficult to fit it; I had to remove the screw and the base of this brace stays slightly bent after seating the Dremel into it as shown in ad picture. So if you wanted to secure the Dremel to a flat surface forget it. But it does fit well in my vice so it will still do the trick for me there. The plastic seems sturdy enough for long term use. So I’m satisfied.

It self destructed in less than 1.5 years. It just sits there, holding my dermal. I don't use my dremel every month. It just sits in this holder. Then one day I go to use my dremel and the plastic holder breaks. So I get my JB Weld and fix it. Great, until today. Then I see another part of this holder breaks. IT'S MADE A CHEAP PLASTIC. IT'S FALLING APART NOW.Unless you plan on replacing this evey year, IT'S NOT WORTH IT.

Just used as sanding tool for small wood parts .. worked great

Good purchase

This vise did not fit my Dremel 400XPR rotary tool. It wasn't even close.Fortunately I got it to fit a B&D rotary tool, with the help of a piece of rubber gasket.