Matte Black Rust Encapsulator Plus | Long Lasting Durable Finish 1 Coat Maximum Rust Protection | Heat Resistance up to 350 degrees Fahrenheit | Matte Black | Pint 2 Pack

Works great and covers in one coat.

The paint was very high quality and went on very well.

This product works so well. I bought it to protect and paint over my 1990 Honda Fourtrax racks and rims that am restoring. I changed out my plastics so the racks really needed some love! They had some rust so I wanted to clean them up and prevent it from rusting more. I used a small paint brush and a small sponge brush to apply the product. I could have sprayed it but I thought painting it would be less waste and more cost effective. This dries down pretty quickly. It is hard to get off you skin even with Gojo. I ended up using 100%r real acetone to get it off my fingers. When it's on...it is really on! Pic on Left is Before, Pic on Right is After.

These work great the aerosol cans have no pressure though

This stuff seemed to work very well. I topcoated with chassis black. The only thing I'd point out... is that so far ordering things from eastwood through amazon... 3 different items, each had like 2wks to get here in cali.

I’ve used this rust encapsulation paint years ago while restoring an antique truck chassis. After many years the coating has held up and no rust. Surface prep is important and it goes on smoothly and coverage is excellent. For my recent project we acquired a set of vintage Salterini peacock chairs. The paint was old and had some surface rust. A little work cleaning them and wire brushing and a coat of Eastwood, topped with a single coat of gloss black and they look amazing. I can’t say enough good things about this stuff. One word of advise. While brushing or rolling this paint on, wear an old long sleeve and long pants, latex gloves too. This stuff is the devil to scrub off your skin. Mineral spirits will help but the amount of scrubbing doesn’t do your skin any favors! OUCH!

This stuff is great I'm on my third can!!!

This is not a two part, bullet proof, end all/be all solution for underbody rust or an underbody coating. It is very easy to apply and work with. It does not seal the lid to the can like some more robust products, but is more of a rust mitigating primer that works as advertised. I think it is ideal as a paint-over-rust primer. I used it as a pre-primer to roll on a bed liner in the tub of a CJ-7. 100% satisfied with it, and would order it again.