ItranMc Window Weatherstrip Trim for 2007-2011 Honda CRV 4-Door SUV

I have owned my 2017 Honda Accord EX-L since it was brand new, and after nine years, the original window moldings were literally flopping in the wind. I normally use OEM parts, but replacing all four would have cost more than $300, so I decided to try these instead. They fit perfectly, look factory-installed, and seal the outer window base exactly as they should. Installation took about 10 minutes for all four, including cleaning the area. I strongly recommend using automotive plastic trim tools and placing painter’s tape along the paint for extra protection. At this time, all four pieces are fitting perfectly. Should anything fail prematurely, I will update this review. Overall, these are an excellent, affordable alternative to OEM parts and completely refreshed the appearance of my car!

They snap in and fit well. It definitely looks a lot better on my 20 year old car with almost half a million miles on it. Just be careful if you try to pull them back off. They will bend if you're not careful. Otherwise, the clips and design hold it in place well and securely.

I watched a YouTube video to learn to remove the old trim and install the new trim. It seemed simple enough, but it was a little more complicated than the instructions in the YouTube video. Looking back, it is harder to remove the old trim than it is to install the new trim. Don't forget to wash your windows and door beneath the old trim before installing the new trim. The trim pieces do not include any instructions for installation. The pieces are individually wrapped and labeled. If you don't have one, you will need to have a plastic pry bar to aid in removal of the old trim. In the video I watched, the installer used a plastic pry bar and a screwdriver to remove old trim and broken clips. I ordered a plastic pry bar kit that included one metal pry tool and I used that along with the plastic pry bar to lift the old trim up and break the first clip. After that you can use your hands to pull the trim the rest of the way off. You will break the old trim clips removing the trim. The old trim is garbage after that. I read reviews prior to ordering and was very hopeful based on positive reviews, but also completely expected the trim to not work on my car. I installed my left rear trim piece first and was sure the one review that mentioned the clips didn't work was going to be my experience because the piece was not clicking anywhere. So after 30 minutes of struggle, I did not think the trim was going to work since the clips did not click into place as instructed in the YouTube video and the trim could be easily lifted back off the door. I asked someone else to take a look and they suggested pushing the center of the clip forward just a bit to give it room to grab under the door. Following that advice, I used a screwdriver to push or bend the center part of the clip forward. This is the part of the clip that will catch under the door frame and keep the trim in place, and after that bend, the trim did click in place and could not be moved. The YouTube also mentions that once it clicks in place it is permanent, so make sure it is aligned correctly before you clip it in place. I clicked my right rear in place about 1/4 inch too far back and it took a lot of pushing, pulling, and shoving and a lot more swear words to finally get it to slide into place and close that gap at the front of the door. Lesson was learned and I made sure to double check the fit before clicking the other pieces in place. If I'd known to bend the center of the clip out to help it catch under the door, removal and installation would have probably taken an hour. I wasted about 30 minutes trying to make the first piece work before I gave up and asked for help and then it took me about an hour to finish up, including time to clean the windows and door beneath the old trim. All of the pieces fit perfectly and they look like factory parts on the car.

I gave it a 4 stars because the rubber gap on the door is not perfect with the window length. However, the price on what you pay for on a car that needs a change, 10-20 year old car, is a bargain next to none. With that said, I would definitely recommend this product and change it every 5-7 years instead of spending an arm and a leg for OEM.

I installed it myself. You can watch on utube they show you how to install it. It fit with my Honda Civic 2008. It takes like 15 to 20 minutes. Honda dealer charge party and labor around $700. Forget it I do it myself.

perfect size, super stable, maintains a good gap coverage, fully compatible with the car, stable enough, hard to install but with enough patience it can be done, good material

Buy these!! They are so easy to install. I watched a YouTube video that was super helpful. I installed these in 10 minutes on our 2010 Honda Civic. They look so good!

Perfect fit for my 2009 Honda civic. It seems high quality, and definitely a great replacement for the money.

The product arrived, and we installed the four rubber mouldings on the windows. Not original Honda window mouldings but the quality is just as good and the price is considerably lower. They were a perfect fit, and we are happy.

Live in Australia.These do not fir our 2012 honda crv..waste of money.

Excellent fit.

En mi caso quedaron a la medida del vehículo y han funcionado bien hasta el momento

weather strips great job fits well