20 Sets T Pipe Connector Tee Clamp Fittings, Fits 1/2" EMT Conduit with PE Adapter Shims

These were perfect for what I needed. Building a garden trellis and needed these to combine conduit pipes. Great fit

These things are awesome! A little tricky to get used to, but once you get the hang of it, easy preezy. I bought another set of 20 because my first project used everything. I did use strictly 1/2" emt conduit for everything so I didn't experience the 3/4" challenges I've read about. I'll buy more as the wife is aware of the success I've had with these. Guess I should have kept it a secret.

Gets the job done but a little difficult to assemble. I used to build a duck pen frame using conduit and chicken wire.

I bought these to build metal EMT lattice, and probably a metal pergola in the future. These were sized as expected and work great for end-tee junctions.

This dupe is smaller and lighter than the Maker Pipe version, but works well for 1/2 inch EMT builds with the included shims. I don't think it would work for 3/4 inch EMT. In the photo, Maker Pipe (which is sized for 3/4 inch EMT) is on the left, this item on the right. I found it a little harder to assemble than Maker Pipe, but once the bolt is tightened down it's very strong. I built a crop cage and this worked perfectly well, plus it was WAY cheaper than Maker Pipe.

They bend easy with wind On the clip.

These worked great, wife bought some shelfs, the legs started to spread apart, these worked great to beef up the support on the legs.

I was building a cold frame for some of my plants using 1/2” EMT conduit and purchased these for joining the pieces together. I was impressed with the fact that there were additional holes in the fittings where I could add a few machine screws if necessary to secure the connections. Unfortunately, it’s necessary to use sleeves (included) on the ends of the conduit in order to fit into the connectors properly. It proved to be nearly impossible to get all of the conduit pieces secured in the connectors at once, and the sleeves had very poor grip which made them slide out of the fittings far too easily. This in turn made the connectors impossible to tighten properly, which meant the whole project was a bust. I found another brand of fastener that, while still difficult to work with, was at least sturdier and a bit longer in order to grip the sleeves better. Overall, I would probably never do another project using 1/2” EMT, as the available fasteners aren’t really made to accommodate them (thus the necessity of the sleeves). I really dislike leaving negative reviews, but in this case, this product was completely unusable for me.

ottimo prodotto