Blue Wave Peel and Stick Pool Cove for Above Ground Pools, 13-Pack – Resilient HDPE Construction – 53-Ft of Total Liner Coverage for up to 15-Ft Round Pools – Sand Cove Alternative

This coving works great. The peel and stick tape was sufficiently sticky to adhere to the walls of my aluminum pool. The foam is not too firm where it won't bend into the corners, and not too soft where it gets crushed or doesn't hold its shape. It's easy to install.

Why did you pick this product vs others?: I needed to replace the liner in my above ground pool after 20 years of service. As I did back then I installed cove base around the pool wall circumference over a bottom liner pad. Cove base is relatively inexpensive, easy to apply and cheap insurance for your pool liner. It serves as a gentle transition between vertical & horizontal eliminating most of the stress to the liner in that area. A good bottom pad shields the liner from any sharp stones or other items that may be present in the base material. These two items (I feel) were the main reasons I got so many years out of my pool liner.

These work good, seams to be good quality. Adhesive stick to the pool wall well. Would by again.

Easy to use and perfect for my pool

Purchased these when installing an 18 foot above ground pool. There were more than enough pieces included to go around the inside. Several of the reviews mentioned them not sticking very well and recommended a spray adhesive which I already had in my garage but did not end up needing because I cleaned the wall with rubbing alcohol first where the adhesive would be sticking and had no problems.

Good product. I had a little extra for my 24' pool. Super sticky, stuck them to the pool wall and they never came loose.

What a product! With someone else helping, these were installed in my 24' above ground in less than 5 minutes - that's not an exaggeration. I have done a few pool liners over the years. I'll never do another without this product. Far superior to a sand cove, and super consistent. It made for a great finish for my latest install. What I liked best was knowing for sure my sand floor is flat, because I could see it meet the wall instead of burying that intersection with sand and hoping it was right. Pro tip: Peel the adhesive backer about 6", and fold the backer piece straight up, press the cove into the corner, keeping the cove tight to the floor and the pool wall with one hand, pull up on the backer with the other. Do this about every 12 inches as you go, and you will install every piece perfectly and quickly. The backer is super sticky, you don't want to have to reposition if you don't have to. If you have a 24' round pool, buy the 24' round kit. I read several reviews about this coming up short and was worried. I have a 24' round pool and I ended up with an extra 1.5 feet. I imagine oval pools could be an issue though, so pay attention to reviews specific to the pool size and type you have.

I read alot of reviews before ordering, many good and even more bad saying they didn't stick but I decided to order anyway. I was very happy, they all stuck well on our 24' above ground and were easy to work with, I also saw some pics and videos where they duck taped the seams between and did that also. I expect them to hold up well for years to come.

Fitment was fantastic. Molded perfectly to the pool. Great protection for the liner and soft so not stubbing a toe on the bottom rails.

Facile à installer

Excellent alternative to banking sand. Much easier to work with and saves time. Only downfall (why only 4 stars) is they weren't as sticky as they should be. I haa couple that came off and flipped under the liner (before water was in) that I was able to flip back and put in place.

Parfais Je n'est eu assez pour ma piscine

Wow. Bought these nearly 10 years ago and it’s an my review feed ?