15mm White 10 x Radsnaps 15mm Pipe Covers

Great product. Bought as replacement for previous set (lasted 10 years - eventually discolouring so needed changing!). So easy to fit & look good - certainly beats painting. The plastic is reasonably thick and snaps onto place well by a small overlap hidden by simply rotating to the rear of the pipe. (I have seen cheaper, thinner alternatives but doubt they would last long). Overall highly recommended- I will be buying more for the rest of the house as we decorate.

This is my second lot, first I bought were silver which I decided wasn't quite right so stuffed away and forgot. These were after I'd finished painting. What I did notice is that where we'd had new radiators no cutting was required, the older ones needed a bit of trimming plus one bent pipe that needed a bit of huffing and puffing to get right. I don't think the man of the house has even noticed or thought I've made a good job of the painting. Very impressed at a small cost.

Great for finishing off our radiators, and so much easier than painting! They are a bit tricky to trim to size (some snapped), but be gentle with a mini hacksaw and you’ll be fine :-)

Brilliant. Just brilliant. No matter how good a decorator you are, you just can't get a finish as good as these on a radiator pipe. Just cut to length with strong scissors, or a small hacksaw. Unfold one end, slide it around the pipe, and use your fingers to open the plastic up as you slide the rest over the pipe. Rotate the sleeve so the overlap is at the back, and you are done. From opening the pack, to having both radiator pipes done, in a couple of minutes. Things to note: If your pipework has bends in it, then unfortunately these aren't going to work. The plastic is too rigid to go around curves. If your pipework has joins in it, then you MIGHT be able to use it - I've tested one on straight solder joint and it covered it ok, but if the solder-ring (or yorkshire, as they are known' couplers have been used, they are even bigger and don't tend to cover very well. These work best on straight 15mm copper, or even plastic pushfit - some are grey, rather than white, and for some reason everyone loves a white radiator tail. I always thought these were a product that filled a non-existent gap in the market until I actually bought them. A 10 pack is great, and the length at 200mm should be more than enough for most applications - if you've got longer than 200mm of pipework coming out of the floor before it hits a radiator, then you could use 2 - The longest length I've used so far is about 180mm. Buy them.

I thought the plastic would be better quality, some of the tubes arrived flattened and do not regain their round shape.

Great product make the usually grotty radiator pipes look really tidy and smart

Easy to use snap on white pipe covers. Make your radiator pipes look bright white and pristine! Thin plastic that wraps around the pipe, easy to cut to length. Add a pipe collar and you're good to go.

These wrap-around pipe covers do a great job of neatening up all my radiator pipes with little effort. Can be cut with a pair of robust scissor. I like this type that wrap all the way around (with a good overlap) rather than the clip-on horseshoe shaped ones, that leave exposed copper showing at the back - they inevitably start to turn round. I'm reckon these things are probably good for a few years, but they will likely yellow with age and the heat from the radiator pipe - unavoidable really, but at this price, I'll just put new ones on!