What type of tool to you put this into a router, a drill, seems too much for a dremel, even if you could find a collette?

The 1/4" shaft Rotary Burrs, are meant for Die Grinders, or Flex-Shaft hand pieces with a 1/4" collet or adjustable chuck.

What tools accept this shaft

drill press, hand drill, router, air grinder with 1/4 inch collet.

Is there an adapter that will allow this to be used in the Dremel 4250?

Sorry Tommy, this is a 1/4" shaft and the biggest burr that the Dremel will take is 1/8". If you have already bought this burr send it back to Amazon and replace it with an 1/8" shaft. Kutzall make the flame in extra coarse 1/8" but be extra careful. This thing will rip through your fingers very quickly. Make sure you have no clothing to get caught up or around your carving area. It will grab the material and snap your shaft. Don't drop it in your lap because you will find it quite painful. Good luck.

Can it be used with a drill instead of a die grinder?

For DIY applications, Kutzall Burrs will remove material at lower speeds (hand drills, drill presses, etc.) but both material-removal rate and control improve as speed increases. Recommended operating speed range is 10,000 - 25,000 RPM.

Number of Pieces	1
Recommended Uses For Product	Blending, Cutting, Deburring, Grinding, Sanding
Manufacturer	Kutzall
UPC	818050020721
Country of Origin	USA
Model number	FLX-12C
Item Weight	28.3 g
Product Dimensions	5.08 x 5.08 x 10.16 cm; 28.35 g
Item model number	FLX-12C
Item Height	4 Inches
Item Width	2 Inches
Are batteries included?	No

Extreme Flame Burr - Very Coarse, Tungsten Carbide Coating - 1/4" (6.3mm) Shaft - Head Diameter 1/2" (12.7mm) x Head Length 1" (25.4mm) - FLX-12C

Details

Description

Specifications

Common Questions