3 mm Baltic Birch Plywood 1/8 x 12 x 12 Inch, Box of 2 B/BB Grade Craft Wood, Stronger Than Basswood Sheets, for Laser, CNC Cutting and Wood Burning, by Woodpeckers

This is perfect for what I needed. I used it to extend my desktop by opening the top drawer and putting this board inside. It goes from edge to edge of the drawer so in effect I added a little L-shape to my desktop. Splendid and great price w/out having to buy another piece of furniture! For longevity, I covered it w/clear contact paper. Appreciated the little thank you note included. : )

Nice quality wood. Perfect for my project. Fast delivery. Would order here again.

Perfect for a project I'm working on. The thickness is great!

both sides clear of defects, but each board slightly warped, but usable for my purposes which were as bottoms to small jewelry boxes.

Yes, these are strong not flimsy. I appreciate these so much.

I've purchased from Woodpecker Wood 3 or 4 times, 12x12 45ct Baltic Birch 3mm (1/8") ply. Before this last box the quality has been very good. However, this package is really disappointing. I wonder if they changed their supplier. Nevertheless, I am getting poor cuts. In those areas I am having to re-cut 2 to 6 times which yields poor quality results, or I have to increase the power from 25% to 90% and still at times have to make multiple re-cuts Again the high multiple cuts again result in worse looking cut as well as horrible soot - even with high air pressure (30 psi) and masking with a verified 60w laser. The problem cutting is aggravating but more so is the time to re-cut or use a cutting device to follow the incomplete laser cut. This is a production killer, and very aggravating. This new box has much more warped wood than the previous boxes purchased and there is slight separation on some of the layers - not common but it is still there. The wood is in a very low humidity environment and the same environment as the previous boxes. I going to try and find another vendor, here on Amazon or other locations. 4/5/22 - Final 18 sheets. I have been printing names 11x5" 2 up per sheet. In all cuts NOT ONE sheet has come out with a full cut. Some cuts I can use an x-acto knife and others I had to over cut (second cut). To get the full cut I had to up the power from 25% (60W laser tube) to 85%. 4 of the cuts took 3 times to finish off the cut. Other cuts it took 2 cuts at the almost full power setting. Some of the non cut areas the laser looked like it was hitting metal, huge white sparking. It appears that there is some kind of material in the middle layer. In the past I have enjoyed wood from Woodpecker, but not any longer. Too much $$$$ for this aggravation and wood cost. The hours to re-cut or carve the problem areas kill any profit available. Got 45 sheets of wood from a supplier on etsy a few bucks less expensive. So far 25 sheets not one miss cut.

These are 1/8 in Baltic birch plywood 12-in squares. It has a nice even grain on both sides. This is three ply. It's a clean and nice looking sheet of plywood. I need 1/8 in for a servo control board for RC and will use six ply hobby plywood which is much more stable.

The 3mm plywood works well for my project. Thank you

Thank you !

The wood performed as it should. I used it to make 16" hoops. The package was delivered in only a few days.

perfect for craft

Good price but slow delivery

The whole set arrived warped, I think because the bottom of the box itself isn't flat. A plastic base or similar in the bottom of the box would go a long way toward preventing this.