2pc Fiber Optic Visual Fault Locator VFL Fiber Optic Cable Tester with 2pcs Singlemode 9/125um FC Male to LC Female Adapter, Red Switch (Mode Number: VFL-50)

Works as it should.

These things are bright! You can fault locate an issue with fiber cable even in direct sunlight with no problem. This has made my job so much easier. It was worth the $30 to not have to cover a cable to see my company provided vfl flashing under a black tarp. Awesome!!!!

Great product the only con i have is that the off position is in the middle and sometimes it gets put on by accident

Opened package, put batteries in device, turned it on and the laser did not come on. The indicator light on the switch came on for continuous and for glint mode but neither mode produced the test light. Replaced batteries and same result. 3 stars due to frustration. Will be sending it back to get it repaired or replaced. My review will be 1 star if they give me the runaround or 5 stars if its replaced/repaired.

Extremely, extremely! Bright laser! Batteries last long and can trace individual strands with ease (minimal microbend)

Fiber does not work.will not order again

This is an extremely bright visible fault detector. It's far better than the ones my employer (over)spends on. I chose to buy my own (10mW) years ago to upgrade from those. Since then, I have also acquired a 30mW and 50mW ruby light. This 50mW light isn't noticeably brighter than my 30mW light. I used a power meter to measure the difference and I did verify it is brighter, but it isn't noticeable to me. Perhaps it's the pattern or the spectral width. Since my power meter isn't rated to the wavelength of this light, I'm not posting its results beyond the fact it did have a higher reading. I did test through a blue bend-insensitive SM fiber and a break was barely visible externally. It would be difficult to notice it. To me, recognizing a break of a blue SM fiber is the gold standard since my company uses them so frequently. I have yet to find any ruby light that can meet that standard, but this one comes as close as I've seen. The 30mW light was on-par. If you have the older yellow SM fibers, you're styling because breaks are very visible with even a 10mW light. If you use a ruby light to identify far-end connectors of a fiber bundle you're running, this is extremely helpful. It lights up the connector cap of any of the jumpers I've encountered so far. If it's not capped, it will light up the ceiling or floor and you can easily narrow down which fiber by splitting the bundle multiple times until you get down to the right one. The one feature it doesn't have that I wish it had (I found helpful in a previous ruby light) is a sleeve/cover over the power button. If it had the sleeve, I could set it, cover it, and be sure it doesn't accidentally turn on or off.

Great Product, long range light works Great, Be careful when storing, on/off switch can easily be turned on and device may be on until you use it again.