3M Scotchgard Clear Paint Protection Bulk Film Roll 12-by-84-inches

Good stuff

Super fault tolerant. MUST use soaper water, makes it sooooo easy!!! Stunning results. My learning process: I cut the shape myself, it's easy to process. Then for the first time I used pure water, and I have 0 experience, tons of bubbles and wrinkles. I was so disappointed but I knew it's because of my lack of skills. Immediately I peeled it off(carefully) and reapplied with more water, the result was instantly better, with only bubbles but no wrinkles, It's impossible to remove the bubbles though. On the next day, I was told I should use soap water. So I carefully removed it again, this time it's more stubborn, I felt I was about to stretch it too hard and actually tear it. But in the end, with tons of water, it recovered and doesn't look like over stretched. So I applied some soap water and reapplied the film, man that was so much different, it's so easy and literally took me like 5 mins to get it in the perfect place. With a credit card I removed all bubble/soap water underneath and result is amazing. I can't believe I have removed this same piece twice and it still worked!!! I am very confident now, I am going to buy again and apply to the front of the car.

Excellent protection. Good transparency. I used this on our sliding patio door. The dog was jumping on the door and scratching the glass. I tried a clear shield from a pet supply but in no time at all that was covered in unsightly scratches. Installing went fine per the instructions. If the price was lower I would rate this a five.

It's easy to work with. Long term durability. I don't know.

Use lots of soapy water on both sides anda small squeegee to install, but it works

Easy application. Amazon fumbles delivery as always

El resultado no es liso, se hace como cáscara de naranja

It has been a few years since i have used any film but this was really easy to use, well, except the area's that had compound curves it took a lot of work to get it correct... The product is totally invisible except where the film stops, but if you can put the film edge on a curve or edge you cannot see it at all....Just make sure you keep the surfaces wet and once in place work all the slip solution out....