Replacement Temple Ear Socks for Oakley Glass Frame OX3024 OX3085 OX3144 OX5055 OX5113 OX5120 OX3133

Though a bit of small size , but managed to solve the purpose

Nose parts was fitting great. But the rubber part for ears doesn't fit at all.

Was mentally prepared for a battle of wills, but these were straight forward. I soaked in warm water, and applied a drop of detergent to the end of the arms. I think the biggest trick is to PULL them on, not push. I used a piece of paper towel for grip. As for the nosepieces, get the old ones out by levering from the end that doesn't have a "dot". To put the new ones in, simply line them up and use a pair of pliers, one side on the nose side, one side on the "back" of the metal piece, so that squeezing the pliers squeezes them in to place. Super easy.

Hard to get on, but once on they fit perfectly.

I have the Oakley Lizard/OX5113 frames and I needed to replace the temple ear sleeves since the original were ripping. I ordered these, arrived quickly and were the correct dimensions. Only gave it 4 stars since they were SUPER tight and difficult to slide on. I ended up finding a small screw driver to run through them to open and stretch them a bit to then slide them on to my glasses. It was still a tedious struggle but they work and now the sleeves on my glasses are without rips and tears.

The ear sock on my Oakley Lizard was getting worn. I bought this to replace the old ear sock. I had no problems installing this with hand soap to lubricate the area. I would use a couple of kleenex to get a grip on the frame and sock so it doesn't slip during installation. Just grip it with your fingers and slowly work the ear sock in. Took about five minutes. Just be careful not to bend or damage your frame during installation.