Dunzy 6 Pcs Lever Handle for Ball Valve Stainless Steel Ball Valve Handle with Hole Size 5 x 8 x 2 mm for Outdoor Faucet Replacement Repair Hose Bib, Blue and Red

High quality and 304 grade stainless steel! Brushed finished. These are not magnetic, and will not easily rust. I had contacted the seller to ask the quality of stainless as other sellers were advertising stainless of a lower quality (201 grade, which would rust). I checked the quality after receiving my items and I’m super happy. Would definitely purchase again. Hope this seller will have other sizes of these 304 stainless steel levers available in the future. The ones purchased fit my 1/2” water ball valve which is on my hose bib. These have a 5x8 mm opening, metal is 2.75mm thick which is sturdier than my old one. I would suggest you measure your old lever with a Vernier caliper to verify your hole size. Note that if your brass valve is 3/4” or 1” size, then you will likely need a bigger hole. Also note that the 2 protrusions on them may need to be ground down on a bench grinder if they are too long. Easily done if you have this equipment.

These are great replacement handles for my brass valves that are in a humid environment. The old ones rusted off. These work great.

I used them on Apollo 1/2” ball valve for my dock shower. Them fit perfectly. I did replace the nut with a stainless steel one.

Quality is good but didn’t fit any of 3 brands of brass ball valves I had, don’t waist your time buy new valves

So much better than painting your own!

This beach house and others like it experience a high rate of corrosion due to the salt air. These handles are a good replacement. As you can see in the photo provided the original handles have completely failed.

My old valve handles rusted and broke, so I have buying the complete valve which is pricey. These replacement handles are stainless steel. Hopefully will last a lot longer.

These handles are perfect. However, the tanges on the front of each handle are too long for my valves, so they do not fit, although the hole is the correct size. The tanges catch on the side of the valve. So, I will need to grind them off to make them fit so that I can open and close the valve.