Upgrade Ender 3 All Metal Bimetal Heatbreak High Temperature Printhead Hotend Kit for Creality Ender 3 V2 Ender3 pro CR10 S4 S5 Ender 5 Plus Pro CS3 3D Printer

All is good..fast shipping arrived Sun not due til Wed.

immer wieder

I bought this when I completely clogged up my Creality Spider 3.0 on my original Ender 3. I needed to finish a project I had going without expending too much more money so I gave this a try.So far this is the best 'cheap' hot end I've had. A few things to note:* It has not leaked. Cheap hot ends are notorious for doing that and I'm pretty happy this isn't.* The wires for the heater and thermistor do come out of the opposite side of the heater block compared to the 'standard' Ender3 hot end. This is true of the Spider3.0 too. You have to make some minor changes to how wires are routed.* This does require the 'barrel' type thermistor (not the glass bulb type). I do like that the holes for the thermistor and heating element go all the way through - it makes it easier to change those if needed. (This is not true of the thermistor on the 3.0 Spider.)* The silicone sock is some special configuration - I'm not sure where I'd get extras. I think you could trim a standard hot end stock to fit, but that's annoying.* Multiple people have reported having temperature fluctuations. I had the same issue originally. I replaced the thermistor and this didn't appear to help, but then re-seated the heating element and it seemed more stable. After a PID, the temperature was MUCH more stable. It seems it's just very finicky about this - more so than any other hot end I've seen.

Does not fit the ender 3 max… way too short and will not work

The media could not be loaded. Can’t hold a steady temp, I have 3$ hotness that hold the temp fine not sure how this made it to production…