DHA Universal Press and Pull Sleeve Kit Car Seal Bush Bearing Remover Installer Insertion Puller Installation Bushing Removal Tool Set

It worked exactly as it should for removing and refitting the bushes on my cars suspension.

Overall this was exactly the thing I was looking for to change bushes in a pair of wishbones, On fist use all seemed to be going to plan and a thought bush was moving...how wrong could I be, it was the bolt that was stretching which eventually broke with the spanners slipping and nearly breaking fingers. I think the tensile rating on these bolts is not high enough for the pressures these are under

It's no good for removing the bushes however the tool snapped in 2Putting them in on the other hand is a breeze absolutely in the park

Used the kit to replace the rubber suspension bushes on my discovery 1. Probably on the limit of the tool for the large ones but got the job done and saved hundreds. The smaller thread got bent at some point during use but for the price you can't complain.

I have tried to use it to replace rear axle bushing for VAUXHALL Zafira B, and the biggest sleve was still too small. Just to be aware if you intended to use it for the same purpose.

For the price this is a good set and is fine if used properly, if using these for really difficult bush removal I can imagine that they would wear quicker than the more expensive ones but for a one off job you can't go wrong

The media could not be loaded. I needed to change front bearings on our car, and went to the repair shop for a quote. They told me it will cost around £300 pounds per side, in case everything will go smooth and there are no complications.I had to watch quite a few videos on internet in order to understand how to use the tool. The tool was helpful and had all the parts needed in order to do the job.I'm very happy I had this tool and didn't have to pay the repair shop prices - I'll definitely keep it for next bearings replacement.

Disappointed with the quality of the smaller rod, apart from that no complaints. On the first use the rod bent and shaved few threads also