Pro Self-adhesive Teardrop Acoustic Guitar Pickguard Tortoise

Went on without issue, it was harder to remove the old adhesive than to install this new one. Great value for the money and allowed me to take this guitar to a gig for the first time in quite a while since I wasn't going to worrie about the pick digging into the top of the guitar.

GOOD PRODUCT, THIN, BUT THEY ALL ARE! STUCK ON VERY WELL. PERFECT FIT FOR MARTIN D-35 (1971).

Fit wasn't perfect but it did the job. Price was right and the service was excellent.

I used these pickguards for 2 fender 3/4 guitars. They are quite thin and were easy to trim and customize to the smaller hole with a pair of scissors. Then, I sanded the inner edge with fine sand paper wrapped around a jar. The adhesive is very sticky so make sure you know where you want it in advance. Oddly, I do feel like I both devalued the guitar and protected it at the same time. The red one looks horrible with it's film on and I almost returned it, but my son wanted it. I was very pleased it looks so nice once installed and the film off. It does have a bit of a printed look but it doesn't take away from the overall affect. The black one has a slight defect in the guard that I didn't see until it was installed and I removed the film. That was a bit frustrating but once they start to get used I'm sure it won't be a big deal with all the other scratches and nicks they get. For the value of protecting 2 fender student guitars and cost I do feel I got my money's worth.

It's great. Fit perfectly and it uses 3M adhesive so it will probably last a lot longer than the original I had.

I'm not sure what they mean by "sheerness", this is not pantyhose, so I only gave it a 4, (in case its actually delightfully "sheer"), but setting that aside...look for the circular decorative sound hole rings on your acoustic guitar, match the curve, pencil that, peel the adhesive, stick that puppy on and forget about it. The first time I got one of these, I wanted to place it at a certain spot, so I wound up custom cutting the curve with an exacto knife, did a less than stellar job, and wound up struggling to peel that one off, where second time around, I just used existing curves to match. My Washburn had no pickguard, so anything would be an improvement, and quite frankly, its a standard enough design you probably won't need to go all fancy on it. Looks fine.

I was hoping for a real pick Guard but this is just a thin piece of cheap plastic with adhesion on the back. Good for real cheap guitars or if you want to bring down the quality of a decent guitar.

This piece worked well for my Alvarez ABT60. The pickguard itself is quite thin and flexible but I used a hair dryer on high heat to activate the glue and make it a mostly permanent feature. Worth the money. (Tortoise shell color). I would purchase it again.

Hello , cette article est parfait .

I removed my old pick guard by warming it up with hair blower on hot. It came off clean . I prepped the area and the new pick guard sticks well and looks great.

Måhända billigt, men mycket fulare i verkligheten än på bild. Printat Tortoise mönster på tunn vit plast med lite vassa kanter. Kommer inte användas. Som någon sagt tidigare, köp det svarta eller leta rätt på ett riktigt om du vill ha Tortoise Shell.

Ça reste très beau sur la guitare et à une qualité incroyable.

Ottimo prodotto