Car Interior Moulding Trim, 3D DIY 16.4FT/5M Insert Pinstriping Tape Cars Styling Decoration Moulding Trims Strip Garnish Accessory for Car Dashboard (Red)

I wanted to add some red accents to my interior to go along with the red accents I already have on my exterior.Depending on your trim, this an be an easy or somewhat tricky install. I had to shave a bit of the insert portion of this trim in a few spots to have it seat properly.There are a also a few spots where it's a bit loose and keeps popping out, but I'm going to try adding a little piece of red electrical tape to thicken the insert portion and hopefully that'll help.Regardless this is a cheap, easy mod. If you change your mind in a few months and decide you don't like it, spend 2 minutes and rip it out. You'll still get longer enjoyment out of it than that overpriced sandwich you decided to pick up for lunch.Note: It is a tad "orangish" as some others mentioned, but not too bad. I still definitely a red. I don't have anything else that's red in my interior to compare it to, so visually it looks red enough to me.

Very very easy to instal and not permanent. Just cut them to size and slide onto vent. Nice to change the appearance and give vehicle’s some personality without permanent modifications! For a more secure fit you could add car safe adhesive glue before applying. I personally like being able to change it out! Only place I wouldn’t apply without adding adhesive is the steering wheel where you touch a lot because it will pop off. Would recommend and bought another set for my mothers car. 10/10

This looks good, I just wish it was a deeper red. It looks slightly orange compared to the red trim in my car. I installed it sparingly on my door panels and dash. It only fits into gaps that are roughly as wide as a credit card. If the trim is soft on at least one side, it should fit. It won't fit between two pieces of hard trim. Using this product is definitely a less-is-more situation. A few accents look good, but it looks really bad if every little piece of trim is outlined.

It's a very pretty metallic red. It doesnt look cheap! I looks really nice. Some places installing were a bit tricky even with the tool. Just be aware if you are going around a corner or edge it will crinkle up the red and cannot reverse that. Also pushing on molding with tool will crease and crinkle it. Work getting it in with top and bottom only to avoid creasing and crinkling.

The trim looked great but I found it was either too thin or too thick to stay in place in most areas. I'm still trying to find a way to keep it in place on my doors because it does look good, but it keeps falling out. Product quality is good.

Spruced up all the doors on a 2020 Ford Explorer ST. Fairly easy to do.The little yellow tool that comes in the kit really helps a lot with install and it also does help to have some actual panel removal tools for the install and for certain areas of the door panel, panel removal tools are required.In some spots of the door panel, I did have to use very small dabs of super glue to hold it in place. Krazy glue is my go to, it works and dries quick. I had previously tried Gorilla glue liquid super glue and that stuff is garbage, it didn’t work well at all.I almost got all 4 doors done with 2 of these kits but I fell just short on the last door, that being the passenger rear, I ran out of material with only the bottom part of the door panel left which is just 2 short pieces so I ordered a 3rd kit and I’ll have definitely extra to maybe find some where else to use.Quite happy with the final results.

I gave up trying this because it just pops out. And it looks bad if it doesn't go in the same depth all the way across the application area. It's just something that's cheap and just needs to be done by the manufacturers to look right.

Easy to install and adds fun to my car.

So I bought this after a friend recommended that it would look good in my car (2019 vauxhall corsa) whilst after installation it does look good. The problem I had with it is thag it is very fiddly, the yellow/orange tool that they provide to help pull the panels out slights so you can slide the trim in is great, but installing this is not a 2 minute job, it does take a bit of time and patience. Also if you want to do the dash in 1 complete strip, it can be done but it is very difficult, I would suggest doing it in 2 or 3 strips.The fitting of the trim also depends on how tight your panels are, most of the trim seemed to just push into place and stay there, but if you have any plastic directly behind the panels you plan to decorate, it does become a bit of a fight. Overall, this product does work and makes your car better looking. Just be warned that it is not an easy install and it does take some time.

Sono veramente stupende da vedere, ma per montarle servono ore!!Forse il filetto che si infila nelle fessure è troppo largo per la mia bmw.Nonostante ciò ho ricevuto molti complimenti per la bellezza

It's ok bit hard to push into gaps

Wouldn’t stay in place around tighter corners of interior trim. Looks really really good though when installed

Ich hatte diese Zierleiste leider fälschlicherweise als Ausen-Zierleiste bestellt. Daher musste sie wieder zurück gesendet werden.