Gas Can Spout Replacement ，Gas Can Nozzle，for 1/2/5/10 Gallon Gas Can Replacement of Old Style Gas Cans Includes Nozzle, Vent caps, Rubber Gasket, Drill bits, Auxiliary Base Cap

Works perfect and great fix for the so called safety nozzle that spill gas everywhere and are far unsafe then these that they use on cans now a days. I had no issues other then the screw ring didn't fit one of them so I just used the original ring with this neck and have no leaks from the neck. Installation is stupid easy.

The ones the government mandates are a joke, causing more spillage than necessary. These ones are so much better.Highly recommended.

Peoduct makes pouring fuel a whole lot easier. Only downside is you have to manipulate the screw cap to fit your gas can. It's a bit of a challenge.

Worked great, came with drill bit ro make vent hole the correct size. Check opening for proper size nozzle, I have 1 old wide mouth that it didn't fit on.

As i was reading other reviews, some said that they did not fit, hoping they would fit my gas containers, i ordered them anyway. I have multiple gas cans that i have purchased over the years, i never knew this but there seems to be 2 different screw patterns for the screw-in gas nozzle connector. Turns out that i have tanks that have them both. In this Replacement Cap Product they give you extra screw-on nozzle adaptor, just in case you have the different containers like i do. So if one screw cap does seem to screw on properly, the other one should, it did for me. the photo of this product actually does show the extra set of screw-on nozzle connector.

The end caps that come with the spouts. The rings do not fit over the spout, and the caps themselves are too small to screw onto the end of the spout. I gave it 3 stars other than that. The spouts fit onto the cans fine and are flexible enough to make pouring easy. The main issue is that you have to take the spout off and use the solid disk to close off the can after every use, or leave the spout open to external debris entry.

Finally, a vent for my gas cans. These gas can spout replacements are great. They fit all my gas and diesel cans. And was able to install the much needed air vent. The cans with the vent in the spout are useless and time consuming. They supply the right size drill bit with this kit. Drill a hole somewhere towards the back of the handle, pop one of the vents in the hole, simple. The vents are a little tough to pop in the hole, but that is needed to give a good seal to prevent leaks. All mine are great, leak free. New spouts with caps to replace all the old crack ones. Good deal in my book.

For anyone that hates the new nozzles on gas cans, this kit is well worth the price. This is absolutely easy to use. the only part that could give someone a little hiccup is drilling a hole to add a vent to the can. This kit provides a drill bit and as long as you have a corded or cordless drill, you are fine. The problem is that the supplied rubber gasket does not fill the void between the stem of the vent and the outside of the can. If you are going to shake the container to either make a 2 stroke gas mix or adding a fuel stabilizer, it will seep out while you are doing a shake. Other than that, the product is good.