SlickMod PreCut Vinyl Smoke Tint for 2015-2022 Dodge Challenger Headlight (3. Headlight, 20% Dark Smoke)

Easy to install but if it's your first time by a sheet of the material and make a couple copies of the template.In case you get bubbles and unhappy like the first try, what if you've done it before? A quick facetime with late body wave tape.It's pretty much the same thing

Extremely difficult to work with. Doesn't fit very well and not the most pliable when heated. Use the squeegee to take the bubbles out and it scratched the film even though I've used the same squeegee on countless others without issues. Waste of $30 of my hard earned money

They were easy to install in just a few minutes. It really enhances the look of the car! I would definitely purchase again, if needed.

2018 hellcat widebody owners...these stickers fit rear and rear sides but about 1" too short for front.

Nice and good quality

The videos they have as demos are for a Honda and a Chevy pickup, so how that applies to your vehicle is very limited. I have a 2018 Challenger and the application was frustrating until I finally figured an affective way to apply them. Had 4 decals and I’m happy with how two came out. So I did a video to show how I finally came up with a good procedure. Hope it helps

I had to clean the lens with water and very mild dawn soap. Wiped it clean with a dry paper towel. Added more soap again and aslo to the film. I peeled half of it off and lifted it i centered it. Wiped off excess soapy water from underneath the film i lifted. Rubbed it on little by little pulled it back if it creased. Be very patoent it was not easy. Very dim at night but i barely drive at night. Its worth it.

The product does not fit and even after adjusting is still too big for the light. Followed the directions and the tint does not stick. I have tinted windows in the past so I am familiar with the process but this product does not look good at all. A waste of money