SMALLRIG A7IV ZV-E1 A7CII A7CR A6700 Screen Protector for Sony Alpha 7 IV/Alpha 7C II/Alpha 7CR/Alpha 6700/ZV-E1, Screen Protector Protective Film 0.4mm Ultra Thin Tempered Glass (Pack of 4) - 3750B

Good fit and easy to apply, touch screen still working as it should.

I bought the Smallrig screen protector for the Sony A6700 after realising that due to it's small factor and more limited buttons and dials, I needed to use the screen a lot to change menu settings and other adjustments. This meant the screen was more exposed a lot more than on my other cameras. The screen protector is very easy to fit and even adjust if you don't get it right on the first go. Just follow the instructions very carefully and avoid fingerprints in the adhesive side of the protector.

I never use screen protectors on phones, probably because of OCD - I couldn't handle any bubbles or other naffness. Figured I'd give these a shot rather than take my camera shop's advice and chop up a phone protector. Well worth it, the fit is perfect, no ragged corners (like my ham-fisted scissor skills probably would've resulted in) and practically indistinguishable from the bare screen. Actually very good value for money getting four in the pack, now I just need another three A7 IVs to stick 'em to!!

Using on my Sony a7600. I normally buy the manufacturer screen protector when I can as I've found them to be high quality, but due to timing I thought I'd give the Smallrig ones a try. So so glad I did. Amazing quality and very easy to apply with no air bubbles, I'd even say it felt easier than the manufacturer ones I have used in the past. Can't recommend this strongly enough !

Easy to fit, matches screen well and lasts well.

Well, that was a right party! In the absence of any usage instructions in the pack I wrecked two of these before finally getting one to stay put without bubbles. Yes, there was a tab on the glass saying - in microscopic type - Back, please peel off the back with this sticker. So that's the back of the glass right? The side that's exposed when it's in place and the peel-bit is for protection from sticky fingerprints while you get it placed? And yes, partial bubbly adhesion is achievable on the other side. But works a lot better if the peeled side is applied to the screen instead! All that said, these really do seem pretty good quality.

They stick on and aren't too obtrusive.

Perfect fit. Very easy to apply. Good price. I would purchase again.

Amazing project for Sony a 7iv

great product at a great price - no bubbles at all!

pur avendo avuto problemi con il prodotto, ottimo centro clienti

Ich bin mit dem Produkt sehr zufrieden. Passform ist super und macht einen hochwertigen Eindruck.

I bought this SMALLRIG protector for my Sony ZV-E1 and it was a pleasant surprise. Despite being an inexpensive accessory, it's clearly well made and so thin that once applied, you can barely notice it. Installation was simple and there were no bubbles. The touchscreen still works smoothly, as if nothing were on it, which is key on cameras like the ZV-E1, where everything is controlled from there. I've seen comments about bubbles or peeling off. I've been using the same protector for a long time, and everything has been great.