2PCS X3 Door Handle Latches Compatible with Can-Am Maverick X3

Very nice easy to put in, mix it so much easier to open the door

Why did you pick this product vs others?: They fit great and work amazing! Can-am come on red straps??? Anyway yes the two lower bolts are too long, I drilled out my rivets and used the spacers from the rivets on the lower bolts, no extra drilling no extra shortening of bolts, no purchase of extra bolts, installed both handles in less then 15 minutes!!!

Other then needing to drill out the rivets and not being able to reinstall the trip without modification these are great.

Works great, so much better than the pull strap. Very easy to install.

Very nice upgrade over the standard pull straps. The only downside is not being able to use the original plastic covers unless you make several alterations to them. But once that has been done it will look OEM

These are simple to install. However; if you have OCD, like me, then you'll want to retain the original lock mechanism cover. If so, there will be some fabrication of the cover to use these door handles. All can be done with a dremel and a few minutes per side and made to look very nice as though they were factory fabricated. (again O-C-D)

The handles are stout and look nice. HOWEVER This is NOT a plug and play, nor bolt-on installation! BEWARE OF THIS, if you're not handy with a dremel and a drill, this project is not for you. 1. You will need to put the handles behind the latches because otherwise they will rub on the plastic covers and wont latch or open correctly. 2. The bolts are too long, reverse them and put the nut facing the inside of the vehicle and you'll solve that problem. 3. You will have to drill out the rivets that hold the OEM straps in place. 4. You will have to drill out the rivets holding the rear latch covers in place and then replace them with new rivets or drill out the supports to accept a bolt of your own procurement. 5. The bolts are the wrong sizes for the holes. There is a lot of slop and play in the fitment, if you were to replace the bolts and nuts with ones that fit the holes correctly, you'd be a lot happier. 6. You will either have to modify the plastic covers or discard them. 7. This is NOT a 15 minute install. This is a couple of hours to make this look OEM and not like you're missing covers with cobbled together parts. Good luck to you all out there. The end result, if you do it right, is pretty nice. But its VERY involved.

Installed these on my 2025 can am maverick ds turbo,good fit and easy to use!

لتركيب هاذا المنتج يجب الاستغناء عن طبقة البلاستك المبطنه للباب ويصبح منظر الباب قبيح بدون طبقة التبطين البلاستيكية

work like a charm

Très bien

Way better then the straps our machine came with. Strong and great shape and colour