Shaker Rail and Stile Router Bits, Newdeli 1/2 Inch Shank Tongue and Groove Router Bit, Professional Carbide Milling Cutters for Woodworking for Cabinet Door

These are decent quality bits for a good price. Working as they should and just what we needed for our cabinet project. The only thing we would change would be getting a 1/4" wide instead of a 3/8" channel.

I used these to make some recessed panel newel posts. They worked great.

Accuracy leaves a little to be desired, but not too bad. They are $100 less than some big names... Tear out wasn't bad, but cut was kinda fuzzy on some clear pine.

They cut fast so go slow.

Work great!

The Shaker Rail & Stile bits do not match up properly. They are basically worthless. I was able to clean up the grooves on the table saw to make them fit.

If you have to make 1 or 2 doors, these will get it done, after while, the cut quality diminished. This was my first non flat face cabinet door project. I honed my skills and learned on this cheap set and proved to myself I could do it and get the results I wanted. Then once I had the skills and knowledge I upgraded to a much more expensive set for the rest of the project. No regrets, I learned on a low cost set so I'm very satisfied with my purchase.

Excelente

Not as good as my Freud but for the price an excellent compromise.

Works

Replacing 22 doors on our IKEA kitchen cabinets, nothing wrong with them, my wife just decided I needed yet another project. Did a few with a dash blade, so time consuming! These are the cats meow, now I'm actually enjoying building them - unless my wife asks, then I'll say something entirely different lol

The match is made simple with the included washers of various thicknesses. Used on Elm and they leave relatively little tear out surprisingly enough.

Not a snug fit when using quarter inch panel in shaker door