BOSS Audio Systems CXX8 8 Inch Car Subwoofer, 600 Watts, Single 4 Ohm Coil

>Great price / performance, and dollar value overall. >Simple / basic poly cone with butyl rubber surround. Cone stiffening ribs are a nice addition. >Not too big/heavy. Not tool small/light... just right for my needs. >Spade crimp lugs are compact and low cost. They reduce the chance of shorting out on anything metal in my installation. >Tinsel leads are nicely woven into the spider. Surprised to see this at the $30 mark. >TS parameters are listed below. Qts .76 is perfect for my infinite baffle / trunk install. Fs: 49 Hz Qts: 0.76 Vas:15 L (0.53 CuFt) Qes: 0.94 Qms: 3.98 Xmax: 6.5 mm >There are reports of people breaking the adhesive, and blowing the coil / cone apart. I added a bead of JB weld plastic-bond epoxy, to strengthen the voice coil adhesive. The total amount was about ~1 cubic cm. The added mass should lower the Fs, which is a good thing for my music preferences. >I am only pushing it with ~250W rms on music, in a low volume SQ system. I am not burping or flexing it with tones. Overall it sounds very musical in my infinite baffle setup. >The biggest thing is it drops right into the rear deck of my Toyota Avalon. No cutting, trimming needed. Looks totally stock. The stamped metal basket comes close to the sheet metal, but it does not touch or make contact. I did bend the terminal lugs downward a little to increase clearance with my trunk torsion springs.

Great quality of speaker and works amazing

Great replacement for my old cracking sub. This one sounds good and deep. I'm not an audiophile, so subjectively it sounds okay to me. Works fine, fits fine, no issues. Easy to install, depending on your car or system. Just understand how to solder, and it should be working great. Would recommend for the price. Also, don't mind the tools in the pic lol

I found a passive subwoofer in the barn I bought many years ago while living abroad. The speaker’s foam was shot and the coil were worse than reluctant so this became the replacement. It is true to size, installed without issue, and sounds great. Good result.

I waited to review in order to "properly" test this speaker - no gauges or genius, just sound and quality. The thing is heavy, you need the heavy magnet to move air, which is what a sub does; more so than a mid-range. I built a close-to proper-specs insulated cabinet from scrap plywood and polar. No cabinet grade and lined with an old beach towel as I had no fiberglass. You can see this is a low buck deal!. I've successfully made enclosures for smaller speakers from small plastic containers (sturdy ones) with lids, and corrugated cardboard- two pieces or three glued together to get to 3/8" thick then cardboard angle and cross brace etc. Back to the Boss. Excellent sound and construction. I paired with an inexpensive low-pass filter from Amazon to keep high frequencies from it. On 'low volume' the 3/4" plywood cabinet shook and you can feel the bass strongly with deep growling lows (my death metal tracks as well as classical). The sealed enclosure worked for me (covered in cheap landscape fabric, lined with old towel) and completed my 10 cabinet setup through a very able non class D type amp! I recommend this speaker but you don't need my advice- BOSS is a venerable brand of many years.

Good item thanks

Finally finished building the box and hooked it up. Sounded great for 5 minutes then blew. Tested at back of speaker to verify it was getting an input and it was, but the speaker wouldn't make a sound. Now to try and get them to warranty the speaker even though id rather have a refund. Sadly I'm out of the 30 days by a bit over a week. I needed 2 total but bought 1 for test fitting. Doubt I'll buy this brand again as the head unit I recieved from them isn't quite up to snuff either. Update: warranty process was super easy. Called the manufacturer and they sent me an email. No arguments or Hassel, just send them a screenshot of your Amazon purchase, Name and address and they will send a new one out. Now just to wait and see.

they are decent for the price they sound good at Low power but they definitely can not handle the 600w max or even 300rms it is in a bad pass box with 2 inch compression chamber I have a 1000w bridged amp I used it with one channel so 500w not even turned half way up the bass is not there but with my little 100w amp it sounds good when turned all the way up it probably gives it 150-175 watts at that wattage the quality goes down.

La bocina es de un tamaño muy reducido y fácil de acomodar en la cajuela del coche y con un buen amplificador, da un sonido excelente y con mucha potencia que se siente desde lejos, estoy muy contento con el subwoofer, se ve la calidad y materiales de 1a. lo recomiendo mucho.

Good product

I've got better bass, it not really bass shaking but it's got some deep bass

Très bon produit, je le recommande 👍🏾

same as described