LLPT 94 Adhesion Promoter 10ml Bottle Primer 1 Pack with 10 Dry Wipes

It works well as intended. I was able to get some carbon fiber trim to stick on my door panels. I first tried without the adhesion promoter and the trim would not stick. Once I applied the liquid and let it dry, it stuck perfectly. It's a good product but the pads are not very wet so even though the part I was attaching was rather small, it took two pads to get enough on the panel to allow adhesion.

I like the wipes, this works well.

As others have said, the pouches are just a dried up cloth in them. The product in the bottle seems to work just fine.

I used this to mount a LED flexible light strip in my vehicle because double sided tape alone wasn't holding tooo well. I used this and it the double sided tape has been holding for a few months now with no signs of failure. This stuff works and easy to apply and worth the money.

When mounting stuff on the car, you definitely need to use adhesion promoter, even for the most expensive 3M mounting tape. This several dollar extra will save you hundreds dollars on the road and headache. This aftermarket promoter works effectively, same as the 3M one. It promised a strong bond and my rain guard survived thousands miles of rain, snow and sun .

I have an older classic car and the spare tire warning sticker that goes on the underside of the trunk was just not sticking. It's about 12"x6" and continued to peel off. I used one of these adhesion promoter pads on the underside of the truck where I wanted to put the sticker, let it set for roughly 4 minutes then re-applied the sticker. Perfect, stayed in place and still secure.

Works great, as expected. Need to let it dry before adding double stick tape

I used this to replace an existing 3m sticky pad on a dash camera I installed incorrectly and it has worked well initially.

When installing the rear door mudguards on my RAV4, the included adhesion promoter was completely dried out. I tried installing them anyway, but the tape barely stuck and they eventually came off. I ordered the LLPT 94 kit to fix it. After lightly scuffing the fender well panels and thoroughly cleaning both the panels and the guards with alcohol wipes, I applied the LLPT 94. It worked like a charm—they are now solid as a rock. Needless to say, we are super happy with the final results! P.S. Since outside temps were a bit below the recommended I heating everything up a smidgen using a cordless heat gun. I'm pretty that also helped.

Previously I had cleaned the area of my car's dash with 90% rubbing alcohol, and applied my 3M Dual Lock which had the acrylic backing tape. It held fine for a couple of weeks, but slowly started to let go, so I bought this adhesive promoter to see if I could improve the bond. I re-cleaned the area with alcohol, and taped off the remaining area with masking tape so as not to get the adhesive promotor anywhere it wasn't needed. The area has some texture to the plastic, so I did three coats of adhesive promoter, letting each coat dry for a few minutes. Then I applied a new strip of Dual Lock and the bond was immediate. No second chances on alignment! I'm glad I got it right the first time. Clearly a superior bond vs without the adhesive promoter. I only needed a single foil pouch to do all three coats, and the applicator had plenty of product on it, not dried out as many have found. I did tighten the lid on the included bottle when it arrived, as there was a strong smell of the product on arrival, but no apparent leakage of the fluid.

Reçu une bouteille avec rien dedans ...La bouteille est vide

I was to stick a security camera with 3mm tape and this adhesive promoter on a wall and it seems to be holding well even during winter!

Use quickly after the opening of the smaller bag, it will dry quick. But it really does a great job! Make sticker and graphic stick 2 to 3 time more than without. Overall i recommend it