Solderless LED Strip Connector, 2-Pin COB Connector for 8mm Single Color Cabinet Lighting, 22 AWG Wire Clamp - 10 Pack

I installed two different sets of COB LEDs using the 8mm Biantie connectors, and didn't have an issue with ANY of them. SO much better than my previous experience with LightingWill connectors, which always suffered from intermittent connections. One thing - Biantie says that the connectors can be pried open with the proper-sized screwdriver. That's a true statement, but what Biantie DOESN'T mention is that just because you can reopen the connectors DOESN'T mean that the connector can be reused after it has been "unsnapped". The tiny plastic tabs/nubs that lock the connectors in the "closed" position have a tendency to shear off when the connector is pried open, meaning that the connector won't lock "closed" again.

These crimp on connectors for LED strip to low volt wire (I used 18 ga to connect to 8mm COB LED strip) are infinitely better than the screw down connectors. You don’t need to strip these insulation on these unlike the screw down. My LED light was occasionally turning off until I replaced every connection with these, now it’s solid. Watch the video in the product images - it’s super helpful for how to align the “teeth” with the copper pads. These are easily hand pressed while the other wire side requires a hand tool to clamp tightly to lock the little clear tabs on the side.

Perfect fit and it's the easiest installation connector I found, and I tried a lot of them.

If you knew to buy these you probably had a good idea of how to use them but without instructions the first thing to is figure out orientation. They show pictures of the two folding sections for the wiring and the LED strip but don't make it terribly clear that the folding sections are down toward the backing side of the LED. I would also want to insert the LED fully into the housing but then the spade in the connector wouldn't press into the center of the pad on the LED so I don't really know if I truly connected them the best but they do work. It does need 22 gauge wire as if you drop any smaller it will not bite into those and stay connected. They are working so far and were pretty easy to install.

They work wonderfully from wire to light strips, but a tad more difficult connecting light strip to light strip. Nevertheless, they work, and they endure.

About half of the LED strip connections I made with these connectors failed. They work better when joining one strip to another, but the wired clip doesn’t always pierce the wire insulation. I finally gave up and soldered all my connections.

Bought these connectors because a different connector caused the lights to flicker, this connector works great. Gets a perfect connection and doesn't cause the lights to flicker.

These are modified 8mm 3 pin connectors. All they did was remove the middle pin on both ends. I guess they thought I was stupid and wouldn't notice, little do they know I order a lot of connectors I mess with a lot of LED lights. I'm guilty of modifying connectors as well but not to sell to anyone trying to pass it off as a two pin connector when it's totally 3 pin. I'll still use them because they still work but this is stillsome BS.

No los eh instalado espero funcionen a lo esperado pero se observan jien hechos.

Répond à mes attentes

These worked great! They were easy to use and even without knowing exactly what I was doing with these connectors I rewired my strip lighting perfectly!! No sodering or wire stripping required!

Facile d’utilisation et rapide !

Product is a good design, I just find that if you're connections are not right the first time, its hard to re open these connectors, and then to re install. otherwise they worked well for my purpose.