SYLVANIA Load Equalizer 27 Watt, Turn Signal, LED Bulbs, 2-Pack.

Easy to install

Had the led hyper flash, this fixed it immediately. Only issue as mentioned is the heat. They get hot, so the heat sink needs to be secured firmly to the chassis to appropriately radiate the heat away, otherwise I could definitely see some melted wires/plastic potentially. Had them installed for over a month with no issues so far, so these are a big win

Easy to connect, no more hyper flash. You don't need 50w like some others sell. I was done in less than 30mins. My turn signal was on its own, only 2 wires. Just a volt meter all I needed to find the hot side with turn signal on. Works with any vehicle. I didn't have room behind my lens to bolt it to the vehicle, I just left it hang loose.

I bought these in order to eliminate the computer error code for my brake lights that is generated by using LED instead of higher wattage halogen. To that goal they work great. Unfortunately, these things get incredibly hot so one would need the proper location to place them. I fully believe they would melt any plastic with which they come in contact and might even start a fire if contacting the right material. I found a place inside the steel wall of the vehicle that worked but one should look and identify the best location prior to purchase. If a proper location cannot be identified , I would not use this. The wire leads are about 4-5 inches on each side and the resistor and heat sink are maybe 3 inches for reference (might be slightly off). Also, the clips they provide to connect the wiring are horrible. They seem super cheap. Just clipping them as shown was not enough to pierce wire coating and make contact with the coper. I had to use pliers to squeeze the halves together in order to accomplish this as well as secure the wires together (so the wires did not just drop out of the clip). A better design here would be money well spent. One might consider getting their own clips to connect the wires. Lastly, they include two plastic zip ties. They don’t reference why (at least what I read/saw in the instructions). I would not use these to secure the heat sync/resistor. If one mounts these as recommended, I would only use a screw into metal (and make sure it not an exterior car panel)

I needed to replace the previously installed resistors (another brand) for my rear turn signals when they began to hyper flash. These were easy to install and fixed my problem.

Hookup is self explanatory easy to read. Works great on all LED bulbs.

Los instale en las luces de freno de mi Tucson 2017 y están trabajando excelente

Used these to fix my cruise control not working due to led taillights on my 2002 Chevy Tahoe. Installed only 1 on passenger side. Worked perfectly. Everything works now. Mounted to metal and made sure wires don’t go near it because it does get very hot

le produit fut utiliser pour changer les clignotants de moto pour d'autres en DEL Le taux de clignotement du clignotant a été rectifié. Le produits fonctionne tel qu'indiqué

Solucionaron mi problema en una Ford Edge 2009!

Needed one of these for the reverse bulbs in our 2018 Equinox to function properly. Easy installation and the builbs work perfectly fine now. They are made in Taiwan not China so hopefully they will last a long time.

Used these to correct a hyper blinking signal light issue when switching to LEDs in a 2013 Jeep Wrangler. Goes between white with yellow strip and black.

It works. No flashy flashy...