KC6300 Universal Wire Hider (3 Feet)

Bought this to hide my KC Titan wiring harness and works great, almost thought I ruined it when I was at the car wash with the power sprayer and was cleaning the windshield when I noticed that I was spraying right into the underside of the wire hider but it never came up off the windshield, so would not recommend doing that to often but it held up great and would buy it again.

I ended up not using them (more on this in a minute). I did test them out and they do a great job of hiding the wires running up the windshield. From a very little distance you can't see them at all. It really looks OEM. Especially if you do both sides for running multiple lights on top. The reason I didn't use them is my windshield had a bigger gap between the glass and the pillars. This made it hard to get enough tape to stick between the wire hider and the glass. My gap was actually wide enough I could hide the wire in the gap. I am keeping these for future use!

What I like about this product is that it looks like it belongs there. I was able to fit a decent amount of wires inside of it as well

Installed an over-cab light bar and needed some way to hide the power cable that runs down the windshield. This was exactly as described and provided the perfect solution. Adhesive was strong and has held up to weather, the rubber part fit a half inch cable well and keeps it hidden. I’ve recommended it to several friends and co-workers.

After cleaning the windshield with both aerosol window cleaner and then alcohol, the double sided tape I used since they didn't send enough 3M came loose on the highway. After redoing it with 3M VHB (very heavy bond) tape coupled with 3M adhesion promoter, the wire hider is almost a structural part of my windshield now. A bit pricy, but worth it since nobody else sells anything like it that I found.

Used this to hide the wires for a dash cam in a Wrangler. The three foot length of the hider is perfect for my application. The only downside I faced was the adhesive channel is as shallow as the tape is thick so that i double-stacked the 3M adhesive tape (after a pre-treatment with 3M 4298UV Adhesion Promoter - Tape Primer). I removed the passenger's side sun visor mounting bracket to run the wire hider along the windshield frame, then replaced it before the primer had set, cinching the wire hider even more snugly in place in the upper corner. The wire hider is exactly what I wanted to secure the wires from the dash cam.

Easy to install, looks perfect. Not aware that it's an add on.

This is a great option for managing wires for offroad lights. Blends in and looks good on my Jeep renegade. Universal fit makes it easy to cut to a customer fit length.This would be 5 stars if it weren't for the crappy double sided tape that's included.I made sure to clean and prep both the surfaces (Windshield glass and the hider). Once installed left it sit overnight to cure. Ran wires the next day. Within a week it was peeling away in a couple spots. Spot patched with leftover tape. In 9 months I've had to redo it 3 times.Now I have to go buy some new tape, hopefully better than what was provided.Buyer beware, and buy you some extra tape with more bonding strength.

2 months old and still sticking on the windshield!Probably need another one for the other side!

Me funcionó , quedó muy estético ocultando el cable de la barra

Sticks to the windshield or trim and keeps light bar wires from flapping in the wind or getting caught on branches

product sticks and stays no problem looks awesome get your truck up to about 70km it starts to howl go 120km and it is near unbearable the howl it makes.

Paying $50 for 3ft of this i was expecting something extraordinary. I have followed all the steps to make sure its installed properly, but a week after I installed it the lower end came off.Not sure if i got a faulty product or its extremely pricey piece of rubber that doesn’t stick