Steel DN Mate Hydraulic Crimping Tool/Hydraulic Crimper with Dies for Stainless Steel Cable Railing Hardware,Battery Cable Crimping Tool DC01 | 9 Hardened Dies, One-Hand Use, Hydraulic Crimper for Cable Railing Hardware, Wire & Battery Cable Crimping 12-2/0 AWG DC01

I recently bought 4 products from Steel DN Mate: -The Stainless Steel Lag Screws for Wood Post of 1/8": Works really well with the tool provided. Because there are Left and Right screw, it prevents the cable from twisting. Good quality, really solid! -The 1/8" Stainless Steel Cable for Deck Cable Railing System: Great quality again! It comes with a cutter that works perfectly. -The Stainless Steel Protector Sleeves for 1/8" Wire Rope: Nice look for a finish on a wood post. I really like the way the sleeve can hide a hole that isn`t perfectly drilled. -And the Hydraulic Crimping Tool: Works perfectly for the Stainless Steel Lag Screws. I crimped the screws at two different places. It seems really strong, even with a lot of tension on the cables and the finish look is great. I am really satisfied with all of the products above. As you can see on the pictures, the finish look is awesome. It was super easy to install. Honestly it took me about 4 hours to install everything. I didn’t waste any screws or cable and no defaults were found on the tools provided. I would strongly recommend this company for your deck project. Overall, it gives a great look at a low cost!

Works pretty well. No issues. Quality product with nice packaging.

Works great for my cable railing. We bought some damn expensive cable railing from a specialty store and it held the steel cable all by tension and it SUCKED. 1,000s of dollars for the railing and after a day or two, the cables would just pull right out. It’s a rooftop deck so that made it extremely dangerous. For 100 bucks, this tool and some railing end bolts, my deck is now safe as can be and each cable is pulled tight with zero slack. This tool made the conversion very easy. I found when crimping 1/8 cable it took 4 “cranks” to get the right crimps. If you place the 2nd crimp too close to the 1st, the steel sleeve will bend. The picture shows the original cable railing and the crimped cable. Yea, the original looked very nice and clean but the cable could be pulled out with slight pressure.

Very good tool. Heavy duty.

Worked good for crimping the cables on my deck cable railing. Has plenty of pressure. Takes some time not as fast as a single action crimp tool. Save yourself some time by not allowing the jaws to open all the way thereby minimizing the strike required to crimp. Otherwise it would be a long painful procedure. Held up for the 150 crimps I used it for.