Screw Terminal Strip 600V + 400V Pre Insulated Terminal Barrier Strip Red/Black (15A 12P)

Excellent, excellent and more excellent. The pressure washer style terminal accepts a bare wire and the jumpers allow signals or power to be distributed neatly. Even with the jumpers installed I can easily get two wires under one and 22 gauge wire even goes under the screw with a jumper. This greatly simplified and neatened up my install.

Do a good job and are affordable. Intended for small wires up to about 16 gauge. Larger can work but smaller is better.

Nicely built, but low cost for short run projects. Not really HIGH quality, but for prototyping they are fine.

The ones that work correctly are fine. However, about 1 in 4 or 1 in 5 have at least one terminal that is unusable. They are not threaded correctly or are stripped and the screws will not tighten. I ordered more than 50, so I have a good sample size. Luckily I ordered a few spares and you can remove the screws and move a working terminal over. If you order these, order spares to use for parts.

Well made sturdy terminal strips that also include a clear cover to protect accidental touching of the terminal. These are large terminal strips s o they take up quite a bit of space. If you have the space these are fine, otherwise look for a terminal strip with higher density.

Would buy again.

Works as advertised. Not much to add, solid product.

Every block had 1 to 3 stripped screw terminals for a total of 8 in this pack. Luckily the terminals are easily swappable, but this does mean that the 5-pack is really only a 4-pack since I had to cannibalize nearly a full block just to fix the broken terminals on the others.