Microjig MF-1004 Dado Stop, Accessory for MATCHFIT Dovetail Clamps

great tool

I set two of the setup gauge with two different blades on my SawStop. The first one when measuring the thickness of the piece , the dado was too loose so I had to use two pieces of paper to shim and the a snug fit. On the second setup, I was extremely careful to setup as exactly as it says in instructions and YouTube made my cut in the setup gauge and the tried a test cut and the first attempt the dado way to loose so ended up after trial and error made a shim from blue painters tape 5 times the thickness of the tape and tested and the fit was nice and snug. I’m not really impressed with this matchfit dado stop. I even pushed leg #3 up to just barely touches the stock and it was still to loose. I’d rather it be slightly too snug that to loose

easy to use

I use this jig a lot - and not just for dados. The only gripe I have is that it’s a one-blade setup. In other words, the setup when done actually trims the jig so if you change saw blades, there may be slight +/- accuracy.It’s not that clear in the description about this.

I found that this is not as accurate as you would think and the cuts are off slightly. Maybe it is me, but I think there are better ways to do dato cuts.