Orion Motor Tech 16pc Blind Hole Bearing Puller Set, Bearing Race and Seal Puller Extractor Kit with Slide Hammer Counterstay 3 Adapters 6-59 mm Collets, Inner Blind Bearing Removal Tool Set with Case

Really impressed with this bearing puller set. The kit comes with everything you need and the quality of the tools is excellent for the price. They feel solid and well-made, and the different size adaptors mean it covers a wide range of jobs. Used it to remove a stubborn bearing and it worked perfectly – saved me a lot of time and effort. Would highly recommend to any home mechanic or professional. Great value for money.

Essential item in my garage now following complete bike rebuild including virtually all bearings. A few tips and techniques had to be learned to get the best out of it but overall very positive and good value.

Done the job required - knock out bike steering bearing outer race

Bought this to remove half shaft oil seals . It took longer to remove the plastic film what the case arrived in than it did to remove the seals good tool easy to use and does the job

Very happy with this tool kit so far. Just rebuilt the lower end on a yamaha warrior that had been sitting outside for two years. Pulled all the bearings in the lower for replacement with this puller and worked with ease. Little to no wear on the tools used. Would highly recommend for any at home repair mechanic.

Excelente producto lo mejor para sacar bujes de sigueñal

I had to remove a needle bearing from a front differential so I bought and tried this tool. After a light learning curve, I was successful in removing the bearing. I subsequently used it to remove two axle seals in which it worked well. For the time and low amount of effort it took the tool was well worth the investment, I consider it paid for. Depending on the bearing, don't expect the bearing will necessarily survive the extraction as you are pulling on the inner race, but then again it isn't common practice to remove 'good' bearings. Seals will also be damaged, but you should never plan to reuse a seal either. All in all a good tool, made of hardened steel. Comes with a short slide hammer (limited use) and a two jaw puller which works well at a smooth consistent pull not creating shrapnel. FYI you will need about a 1/8" to 3/16" of space minimum behind the bearing/seal for the tool to penetrate and grab.

naja is hald billig material.aber der gleithammer funktioniert

Ok. I was very skeptical but this is a nice set. I needed to pull an inner axel mount bushing on a ford escape. The collet’s open surprisingly wide so I think it would fit nearly any dimensions wi the in reason. I tried the the static puller first but I had to position it against the alloy transfer case and was scared I would break the case but it would have pulled it out for sure. I then switched to the slide hammer and I can say without a doubt it will take a lot of abuse. I had to slide that hammer as hard as I could as my bushing was seized in there. Eventually it pulled out. Never once did o feel the collets or hammer or any connections would break. Highly recommend !!