Ekena Millwork PNL20X28AS-01 20"W x 28"H x 1/2"P Ashford Molded Classic Wainscot Wall Panel, ‎Factory Primed White

It looks classy and expensive, easy to install on the wall. We put it in the bathroom around a picture and it looks like a part of millwork adding a nice decor element.

How cute are these!? These were so easy to use for small spaces. These were easy to paint and very lightweight so easy to instal with liquid nail glue.

I used dabs of locktite P3 and a pneumatic nail gun to install. I would not recommend hammer and finishing nails as the panels are fragile. Locktite alone will not hold these in place as the locktite takes awhile to cure and the panel will give into gravity, perhaps adhesive and painters tape may work but I didn’t want to take a chance on making a big mess and wasting a panel. The nail gun was set to lowest penetration and the holes were easily patched with painters caulk and then painted. Far cheaper and loads less work and headache than building the frames myself and after painting I cannot tell the difference. The ordering, measuring and placement was the most difficult part as spacing, wall length/height and receptacles drive the panel size so be prepared to spend a lot of time in the ordering process. I used a cheap B&D laser level and Kreg multi measuring tool to get my intervals. Installation of the entire 14x15 room took less than two hours including caulking.

The product is beautiful but it is maddening as the sizing is totally inconsistent. I had to buy and return multiple times to try to get ones that matched. I finally gave up and used the ones that were closest in size which varied 1/4” to 1/3 “. Pain in the butt but the results are stunning and I don’t think anyone else will notice.

I had an existing chair rail and added thin decorative molding below it with these pre-made frames under that. It looks so nice! Yes these are not wood but once they are on the wall, they look they are and that is all that matters. It is also a bonus that there are no miter gaps in the corners like traditional wood built frames. The material is lightweight but durable. I used 2" 18 guage brad nails and shot into the studs where I could and into the drywall where there were no studs. Recommend a thin bead of caulk on the outside and inside to finish it off. All the people leaving negative reviews bought them thinking they were actual picture frames lol

So easy to install. I used two sided sticky tape but you can use a brat nail. No assembly needed. Adds a nice touch to any wall.

This is a frame in only the most basic sense of the word. Let me count the ways in which this frame disappoints: 1) It’s made of what appears to be cheaply formed foam, like one of those old fashioned toy gliders. It’s a very cheap material that feels like it will snap if you look at it wrong. The surface is poorly finished, with lots of defects like bumps and pits and overspray. 2) There is no recess for your picture or canvas to set into. This is literally just a flat, one-dimensional rectangular piece of plastic. I guess that’s what is meant by “picture frame panel”. 3) There is no glass or Plexiglas included. If you want to put your own glass into this frame, you’re out of luck. There is also no hardware to use for hanging. Granted these things were not listed in the description, but when buying a picture frame, people usually assume these are included. 4) If all that weren’t bad enough, the measurements of this frame were taken from the outside edge. If you buy this to frame a 16”x20” photo, you will be covering up a significant amount of the picture. The dimensions of the opening are roughly 12.5”X16”. I have no idea what size picture this is meant to frame, but it certainly doesn’t work for the 16”x20” picture I intended to use. Normally frames are sold with the inside dimensions in the title, and the outside dimensions listed in the description. I am sending this back for a refund. I suppose if you are buying this for some kind of arts and craft project (set decoration?), it might be useful. But given the amount of work you will need to do to make this frame presentable, I would be inclined to buy a few scraps of trim from a hardware store and make something myself. As it is, this is way over-priced for what you get.

We had planned to make wainscoting by hand but these ready-made moldings are way better, cheaper and easier. The product arrived with zero damage, uniform size and in ready-to-use condition. The paint adhered well to the material and so did the glue we used to attach the molding to the wall. It was so much better than we expected and end result was beautiful. Highly recommend.

Las molduras son de muy buena calidad y fácil de instalar, pero sólo recibí 2 y no he recibido información de cuando recibiré el resto (El mensaje de Amazon dice "Entregado")

Worked as intended, for adding decorative moulding to an interior door. Affordable, lightweight and easy to apply. The product was shipped very carefully - unfortunately I wasn’t as careful - but this was seamlessly rectified with a drop of superglue.

Great product, easy to install.looks great

not what I thought it was going to be--not sure if I can use it

So these seem fine for what they are, however they're probably not the product you're looking for. This product is just the frame, there is no backing, no glass/plexiglass. It's literally just the frame. I bought this instead and it was what I wanted: MCS Trendsetter Poster Frame (2 Pack), 16 X 24-Inch, Black