Nilight LED Light Bar 20 Inch 126W Spot Flood Combo Led Off Road Lights Driving Light with 16AWG Wiring Harness Kit on Truck SUV ATV UTV

Alumbran muy bien

Great product and easy to install. Would be nice if there was prions for mounting. Excellent clear light for night riding.

So far love the brightness, quality, and ease of install. I bought 2 lights kits to install on my utility tractor for winter snow removal front and rear visibility. I bought the light kit that included the wiring harness as it was the most cost effective and I was running both separately. Product notes say you can connect 2 lights to one harness, which is true, but those would have to be installed within 3 feet, which was not my case. So 2 lights can run on one harness, but know they need to be installed close to each other. I cut off the extra connectors and sealed to waterproof the wires.I bought a mount kit for the front. I needed to add longer screws to clamp to my front guard . I did not want to drill through the front steel guard at this time. May do that in future. The rear was mounted on the rollover frame and the holes I used were already factory made, so that was easy. The mounts on the light are adjustable and slide the full length of the light body. I ran the wire down the outside and secured with special outdoor zipties. The switches included on the harness are waterproof and light up when on, which is great addition! Once I drilled a hole in the plastic dash the switches snapped into the opening securely. Use a tapered bit as you can test the hole size as you go!! The switch had a quick connector so once that just fit through the hole I know the switch would lock in securely.Install was easy and has inline fuse built into the harness. All parts needed to connect are included, even extra fuses and connectors. I used heat shrink to seal all connections since they would be exposed to water and snow. Also, since I mounted the light upside down, I seals with caulk the area where the wire enters the light body, just to be sure. I recommend these to add a bright light to any application!

nice and bright!

Light works great, the very low power consumption vs high lumens output is simply amazing. The wiring harness comes with extra connections for another led light. I will be getting another one to add on.•Check out Avortec.com for Advanced Technology Welding Machines. We have the only 6+-in-1 welding machine! Starting at $2,500, you save $12,500+ If you had to buy individual welders from other companies.• I recommend painting the larger bolts with rust prevention paint, and wd-40'ing the hell out of it all before tightening as these bolts will likely rust up quick in humid and salty areas. If you ever need to remove it the oil will keep it so you can years later.• Electrical tape around all connections, even interior switch.• Make sure wiring isn't rubbing on metal/ secured to metal with zip ties, etc.• You will need a hole cutter or drill bit to make switch hole in dash, etc.Lit 40% of my 4 story house up with this light on a old 12v car batt holding at at 9.2v.• Tested it on back porch and beam made it to the tree line about 80-100ft away, would go much further at 14v when vehicle is running,• Make sure they are angled slightly downward for on/road so not to blind oncoming vehicles.•Check out Avortec.com for Advanced Technology Welding Machines. We have the only 6+-in-1 welding machine! Starting at $2,500, you'd save $12,500+, If you had to buy individual welders from other companies.• Install should only take 30 minutes to 2 hours depending on vehicle and experience. It took me about 4hrs, however I had to remove several old rusted out lights, paint and remove old wiring, among other things.• My only problem was I got a bracket that wasn't threaded, completely free under warranty, Nilight sent me replacement brackets and they worked perfectly.