YFM660 Carburetor Carb With Oil Filter & Spark plug Compatible with 2002-2008 Yamaha Grizzly 660 4-Stroke Engine Replace PD42J 1UY-14451-00-00

Carb installed well enough until installing the boot between the air filter and the carb.It turns out the hole on this carb is about a quarter inch bigger than OEM. This makes it impossible to install without modification. I placed four small slices in the end of the boot and used some dish soap and water as lubrication. I also heated the boot with a heart gun. Also, I removed the boot from the airbox to get a better angle. Eventually, I got it on and put on the pipe clamp.Other than it not being a factory fit for a grizzle 600, the carb seems to perform way better then my OEM carb. As long add the boot holds up with my small stretch cuts, I think it will be a pretty good purchase.I gave it three stars because the boot issue makes an otherwise simple install to be a real pain.

It's close but both the airbox and intake sides are just a tad bigger and actually don't fit the oem boots. The one provided doesn't either. Also, I wish it would include the two orings for the oil change. In the end, I shoehorned it in, changed a few vent lines and it started right up and I adjusted the idle speed down a tad and it was good to go.

Not an exact match, but fits well and is running well. Idle is a little high, but I need to adjust.

Perfect fit and worked great out of the box but, it immediately leaked fuel out of the over flow tube. After fooling with it for about 3 days I finally figured out that the gas was coming from the cracks in the bowl around the drain screw. Even though it works good its actually useless because of the gas leaking out of it. And of course there's no response from the seller.

Works perfect! A little bit of adjustment and quad runs like new

This an easy install. Works great

livraison rapide

Does not fit make and years it states it does