Mcbazel SURECOM SW-111 100W/10W SWR & Power Meter for CB Radio, CB Antenna Analyzer with FWD/REF, 27MHz CB Radio Tuning Kit (NOT for VHF/UHF)

Great little meter. Everything you need. Nothing you don’t. I only bought it because my current SWR meter came from radio shack and I have no idea if it still works, is rusted out internally, etc . Been in the box for probably two decades so that should tell you how often you will probably use one of these! Don’t spend a fortune.

The meter worked perfectly for me and I haven’t had any problems or issues using this meter. Great for checking your SWR readings. I use this meter to check my wattage output on my cb radio.

I was very happy with the meter especially when I saw other meters priced $10-15 more

The meter was a bit smaller than I expected. It also did not have rubber "feet"--easily remedied with some stick-ons from the hardware store. The SWR function worked as expected at power levels above 10 Watts. At lower levels, it underestimated the actual SWR. The power meter function is highly frequency dependent. It appears to have been factory calibrated for 27 or 28 mHz. The power calibration is adjustable with the two "mini-pots" as seen in the picture. The left-hand pot adjusts the low (10W) range, and the right hand pot adjusts the high (100W) range. At lower frequencies, the meter is much less sensitive so the calibration is way off. However, the readings are consistent, so I constructed the following table. To get the (approximate) actual power, simply multiply the meter reading by the appropriate "multiplier" in the table, which were determined using an FTDX101 into a 50-ohm dummy load. BAND MULTIPLIER 80M.........100 40M...........25 30M...........10 20M.............5 17M.............2.5 15M.............2 12M............1.6 10M............1.0 6M...............0.5

Does what its supposed to

Compre este medidor para mi radio CB pero resulto que no es precisa me sorprende ya que la marca es excelente porque tengo otro medidor digital y con ese realice las comparaciones y no fueron los mejores resltados pude tener la mala suerte de recibir una unidad defectuosa solitie la devolucion y compre otro de marca Astatic

i brought this to replace my old swr meter i got both channels 40 and 1 adjusted to 2 jest above the 1.5 swr wasn't hard to use use a jumper cable between the meter mark trans then attached the jumper into the cb radio then attach the antenna to the ant side on the meter set the left button to 10wfd next set the right button to swr turn on cb tune to channel 40 key mic then adjust the meter to set then move the 10wfd switch down to the 100w ref then read the swr do the same on channel 1 if swr is higher then 1 adjust your antenna by cutting a fraction of the bottom antenna the recheck swr on both channels if the swr on 1 is higher then 40 you'll need to raise your antenna to get your swr equal or close to each reading this is a great meter also i checked my out put power set the right button 10 w if you have a stock radio as mine is stock the set the right button to pwr then key your mic then read the f s numbers on the lower scale of your meter

I haven’t used it yet but it looks promising

Sicuramnte un ottimo prodotto.

atendeu as expectativas

Tut was es soll und hat den Messwert des Profigeräts bestätigt, mit dem die Antenne eingestellt wurde.

I would recommend this bit of kit to anyone, delivered very quickly, and packaged great too, and good value for money, great quality.

Fast delivery and happy with product I ordered, well done keep the good customer service up.