1inch Handlebar Grips, Cable Throttle Hand Grips, Non-Slip Rubber Motorcycle Handgrips Fit for Harley Davidson Touring Dyna Softail Sportster 883 1200

Great value, looks awesome. Super comfortable. Held up over 1000 miles so far! Would buy again!

I installed a pair of these grips on my 1997 Harley Davidson Ultra Classic. Three months later the end of the throttle grip fell off leaving the handlebar exposed. I reached out to the company about warranty. They asked some simple questions and a photo of proof. A week later I had a new set of grips delivered at no cost to me. I really like the feel of these grips. Just a few recommendations when installing use a very light film of white lithium grease on the throttle tube, and a drop of blue loctite on the grub screws for the clutch side. I'm very happy with these grips.

Item is as described. Knurled, comfortable, made of aluminum, went on a 2019 iron 883. Clutch side does not fit in the housing, so it is held on by a little allen screw - still looks pretty flush though. Just make sure the screw stays tight. Throttle side has a functionality issue, of which all metal grips seem to be plagued - which is the tendency for the throttle to stick. Genuine Harley grips are plastic where the grip meets the linkage, and that allows it to rotate with little to no resistance. A plastic or nylon washer should be included or just glued to the end. I had to grind the grip a bit, lube the contact point, and tighten the idle cable to get it to return to idle position on its own. Be mindful of that, as one could quite easily wreck if caught by surprise. Otherwise, installation was easy

Looks great, easy to install.Great price

Good look and feel. didn't fit a 01 sportster xl883c with stock cable, this has an offset cable setup and your cable will not fit. Misleading fit-ment of product. So buyer beware order longer cables also.

They required a little finishing to remove burrs and sharp overedges. Finally had to Drexel a wee bit off of the aluminum housing on the bike. The groove on the grips for this should have been cut 1/4 mm deeper. There was just enough interference friction that the throttle wouldn't snap back when released. A few minutes of fine tuning and they're on and functioning. They really do look great. Will ride it in the morning. Even with all of the extra fiddling, I'm happy so far. The great price helps alot.

Fit great on the bars and comfortable with a positive feel

these are great! I was gonna purchase these ones that were $150, I’m so glad I chose these! They were great and I have no problems with them whatsoever

Non conforme , poignée de gaz se bloque quand on remonte les comodos

Extremely happy with my order

Fit on my Harley Sportster great. These are a nice size, not too thick to grip well with your hand. (I would consider my hands to be medium sized, not overly large or small). The material they are made with is also comfortable to grip. Overall great product for the price. I highly recommend.

Fixierschrauben drehen durch und halten dementsprechend nicht, daß gewinde ist ultra schlecht verarbeitet.

Left side is not solid it twists in rubber