Nitaar 5 Tier Heavy Duty Garage Shed Racking Shelving Storage Units Boltless Shelves - 150cm x 70cm x 30cm

Very sturdy shelves, the cross member on each shelf gives extra sturdiness. slight difficulty slotting in the sides, had to slightly bend the "tongues". Otherwise excellent

Bit fiddly to assemble but although seeming a little flimsy whilst putting together are actually very sturdy once complete and fixed to a wall. Good value for the price. Would buy again.

I'm not sure what these are now priced at but I feel like I had a really good deal at the time (believe i paid less than £20). The shelves themselves do bend without anywhere near the rated weights on them but it's not too much bother to cut more. The frame is actually ok for purpose. Easy to put together, adjustable heights etc. The only issue is the thin flimsy shelves themselves

Although on the face of it, putting a rack together with "just a hammer" sounds appealing, to actually get the lugs to seat properly so that the unit is actually "square" is a bit more tricky. After knocking the first few bits together, I noticed the the connector lugs just went through the first hole, then splayed out before going through the second hole in the pressed lug slots. Indeed, if you aren't too worried about the unit being solid and stable, this may suit you. However to assemble the rack as intended you will need to use a screwdriver or another sharp implement to slightly widen the slots and carefully maneuver the lugs into each slot whilst simultaneously bending each lug inwards. So definitely not recommended unless you fancy an annoying, time wasting challenge. However, once assembled it is surprisingly rigid, considering the very thin metal from which it is made. ( BTW the shelves are actually thin sheets of MDF not metal)

As the total says, it is in fact two identical units that fit on top of each other and clip into place, i only used one section as you can see, did the job perfectly. Its simple to put together if a little fiddly - tip is to slightly press the bit that slot into the frame inwards slightly with your thumb, that helps it fall into place. Just take your time, and you wont go wrong (famous last words) frankly this is cheap do dont expect sone industrial garage shelving, but it hold me heavy compressor and pressure washer with no problem. Also sold on the unused section and recouped £20 !

Bought two - first one took all day second a couple of hours! Slightly fiddly.

I’m adept at flat packs but this took 2.5 hours to assemble. The MDF shelves are warped so they won’t sit flat and overall the unit is unstable and not sturdy. I’d pay a bit extra and get a better quality one next time

The metal tongues from the legs into the shelves have very little tolerance and some were very difficult to guide into place.The metal parts also had some sharp corners which caused small cuts and scratches.The unit is fairly sturdy for the price.